Instruction Sheet

3
11� Add a second nut onto each of the screws to secure the
card reader.
A
B
12� Install the harness by pushing the white connector end onto
the 6-pin post connector labeled as AA3 on the control board.
A. Nuts B. Card reader
A
B
A. White connector end of harness
B. 6-pin post connector labeled as AA3
13� Replace the control panel using the original TORX screws.
6� Remove the card reader cover.
A
A. Card reader cover
7� Discard card reader cover and retainer.
8� Snap bezel onto control bracket. See Illustration in step 9.
9� Install the 3 screws into the front of the control bracket and
install a nut onto each of them. If the 3 screws have been
pre-installed, skip to step 10.
A
B
A. Screws and nuts B. Bezel
10� Install the card reader according to the manufacturer’s
instructions.
INSTALLING CARD READER-SINGLE HORZ WASHER AND MATCHING
DRYER
1� Unplug washer or dryer or disconnect power.
2� It is recommended to cover the top of the washer or dryer
to avoid scratching the top or the console parts.
3� Pull out and remove dispenser from washer.