Instruction Sheet

5
1� Unplug stacked washer/dryer or disconnect power.
2� Remove the dispenser drawer. Use a screwdriver to
push down the tab to release the drawer.
3� Remove the four control panel TORX screws.
4� Remove the four card reader bracket screws.
5� Remove the snap-in card reader cover.
6� Discard the card reader cover.
7� Install the 3 screws into the front of the control bracket
and install a nut onto each of them.
8� Snap bezel onto card reader bracket.
9� Install the card reader according to the manufacturer’s
instructions.
10� Add a second nut onto each of the screws to hold in
the card reader.
11� Plug the wiring harness into the card reader and the
card reader port on the control board at AA3.
12� Replace control panel using the original TORX screws.
INSTALLING CARD READER-W/D STACKINSTALLING CARD READER-W/D STACK