Technical Specs

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
PAGE 2
Debit Card Ready
This washer/dryer is debit card ready. It will accept a variety of
debit card systems, but does NOT come with a debit card reader.
Refer to the debit card reader manufacturer for proper washer/dryer
set-up. In models converted to a Generation 1 debit card system,
debit pulses represent the equivalent of one coin (coin 1).
CONTROL SET-UP PROCEDURES
IMPORTANT: Read all instructions before operating.
n
Coin Payment Models: Insert service switch key and turn
counter-clockwise.
n
With Card Payment System: Once a Generation 2 debit card
reader is installed (according to the reader manufacturer’s
instructions), the set-up modes can be changed by inserting a
set-up card (supplied by the reader manufacturer) into the card
slot. Inserting the service switch key and turning will only access
the service mode.
The washer/dryer is now in the set-up mode. The bottom
temperature setting buttons and the lower portion of the display are
used to set up the digital control for the washer. The upper three
fabric setting buttons and the upper portion of the display are used
to set up the controls for the dryer.
The display can contain four numbers and/or letters and a decimal
point on both the top and bottom display portions. These are used
to indicate the set-up codes and related code values available for
use in programming the washer/dryer.
Start Operating Set-Up
Washer/dryers are preset at the factory and do not require any
programming. However, if you want to change the settings, follow
the ‘Set-Up Codes’ guide.
The first code shown in each segment is the factory default setting.
The set-up code is indicated by the one or two left-hand characters.
The set-up code value is indicated by the two or three right-hand
characters.
Washer control
setting buttons
Dryer control
setting buttons
Display
Dryer display
Washer display
CODE EXPLANATION
6 06 REGULAR CYCLE PRICE (DRYER)
6 06 Represents the number of quarters (coin 1) needed to start the dryer;
may adjust from 0–200 (See VALUE OF COIN 1). Advance from 0–200 by
pressing the upper left (COTTON/WHITES) button. Factory default of
6 quarters = $1.50.
g
Press the lower middle (WARM) button once to advance to next code.
6 08 REGULAR CYCLE PRICE (WASHER)
6 08 Represents the number of quarters (coin 1) needed to start the washer;
may adjust from 0–200 (See VALUE OF COIN 1). Increase by pressing the
middle left (COTTON/WHITES) button, decrease by pressing the lower left
(HOT) button. Factory default of 8 quarters = $2.00.
g
Press the lower middle (WARM) button once to advance to next code.
7 05 REGULAR DRY TIME (DRYER)
7 05 Represents the number of minutes per quarter (coin 1).
Factory default of 5 minutes per coin. Example: 6 quarters
x 5 minutes = 30 minutes. By pressing the upper left (COTTON/
WHITES) button, value adjusts from 1–99 minutes.
g
Press the lower middle (WARM) button once to advance to next code.
SET-UP CODES