Use and Care Guide
Quick Start Guide
Setting Up and Using Your High-Eciency
Front Load Washer
CONNECT NEW INLET HOSES
TO FAUCETS
1
CONNECT INLET
HOSES TO WASHER &
CHECK FOR LEAKS
3
Do not overtighten or use tape or
sealants when attaching to faucets.
Make sure that both hot
and cold water hoses are
connected to the correct
faucets. The washer will
not operate unless both
hoses are connected.
IMPORTANT:
Make sure that water
faucets are turned on
fully before using the
washer for the rst time.
If there is no/low water
pressure to the washer,
the display will scroll “lo h2O”. To clear, open
and close the washer door.
4
CLEAR
WATER LINES
2
Do not
overtighten
or use tape
or sealants
when attaching
to washer.
KEY AND COIN BOX*
FREE FAX
800-ESD-KEYS
012124
DO NOT
DUPLICATE
LOCATION OF KEY
Coin box key (shown) comes
taped to coin box lock.
Document the key code
(engraved on coin box key)
in a safe place.
If key is lost, contact
1-800-523-1510 for
replacement (not covered by warranty).
Have key code handy; otherwise, locksmith
will have to drill out coin box and
replacement coin box (part no. 4396671) will have
to be installed.
*Applies only to select models.
W10827423A
W10827437A - SP
CONNECTING WATER/SECURING DRAIN HOSE
Make sure that the washer is level (see the “Level Washer” section in the Installation Instructions). Run
a wash cycle to verify that the washer is working correctly and has no leaks at faucets and inlet hoses.
Insert new hose washers (in
separate bag) into each end of inlet hoses.
Firmly seat washers into couplings.
Turn on
faucets and
check for
leaks at both ends of hoses.
Position the washer so that the rear
is within approximately 3 feet (900 mm)
of its nal location.
Keep the washer in the
upright position; using a
1/2" wrench, loosen each
of the 4 shipping bolts
on the rear panel. Once
each bolt is loose, move
it to the center of the
hole and completely pull
out the bolt, including
the plastic spacer. Discard
the bolts and spacers. Close the bolt
holes with the 4 transport bolt hole plugs.
REMOVING SHIPPING BOLTS
Shipping bolt
Install and secure the
drain hose in a manner
that will avoid it coming
out of or leaking from the
plumbing/drain.
Do not seal or
put more than
4.5" (114 mm)
of the drain hose
into drainpipe or standpipe.
5
114 mm
(4
1
/2")
4½"
(114 mm)
and/or