Installation guide

REVERSING DRYER DOOR SWING

You can change your door swing from a right-side opening to

left-side opening, if desired.

Remove the Door Assembly

1. Place a towel or soft cloth on top of work space to avoid

scratching of the surface.

2. Open dryer door. Remove button screws from cabinet side

of hinges. Loosen (do not remove) top screws from cabinet

side of hinges.

7. Be certain to keep cardboard spacer centered between

doors. Reattach outer door panel to inner door panel so

handle is on the side where hinges were just removed.

door catch

plugs

8. Reattach screws at top, bottom, and side of door (5 screws).

hinges

3. Lift door until top screws in cabinet are in large part of

hinge slot. Pull forward off screws. Set door (handle side up)

on top of towel. Remove top screws from cabinet.

4. Remove screws attaching hinges to door.

5. Remove screws at top, bottom, and side of door (5 screws).

9. Attach door hinges to dryer door so that larger hole is at the

bottom of the hinge and the hinge pin is toward the door

front.

Holding door over towel, grasp sides of outer door and

gently lift to separate it from inner door. Do not use a putty

knife to pry apart. Do not pull on door seal or plastic door

catch.

10. Remove the 4 screws that attach 2 plugs on the left side.

Attach plugs to right side using the same 4 screws.

11. Insert screws into bottom holes on left side of cabinet.

Tighten screws halfway. Position door so large end of door

hinge slot is over screws. Slide door up so screws are in

bottom of slots. Tighten screws. Insert and tighten top

screws in hinges.

12. Close door and check that door strike aligns with door

catch. If needed, slide door catch left or right within slot

to adjust alignment.