Installation Guide

31
ELECTRONIC CONTROL SETUP INSTRUCTIONS
Code Explanation
J. Cd
PAYMENT MODE (COIN/DEBIT OPTION)
J. Cd
J. C_
J._d
J. Ed
Both coin and debit selected. Press the
DELICATES button three consecutive times to
change this selection.
Coins selected, debit disabled. Press the
DELICATES button three consecutive times to
change this selection.
Debit Card selected, coins disabled. Press the
DELICATES button three consecutive times to
change this selection.
Enhanced Debit is self-selected when a
Generation 2 card reader is installed in the dryer.
The Ed option cannot be manually selected or
deselected.
■
Press the PERM. PRESS button once to
advance to next code.
L. 00 PRICE SUPPRESSION OPTION
This option is either NOT SELECTED “OFF”
or SELECTED “ON.” This option causes the
customer display to show “ADD” or “AVAILABLE”
rather than the amount of money to add. (Used
mainly in debit installations.)
L. 00 Not Selected “OFF.”
L. PS Selected “ON.”
■
Press the DELICATES button once to change
this selection.
■
Press the PERM. PRESS button once to
advance to next code.
n. CE
CLEAR ESCROW OPTION
This option is either NOT SELECTED “OFF” or
SELECTED “ON.” When selected, money held in
escrow for 30 minutes without further escrow or
cycle activity will be cleared.
n. 00 Not Selected “OFF.”
n. CE Selected “ON.”
■
Press the DELICATES button once to change
this selection.
■
Press the PERM. PRESS button once to
advance to next code.
U. 00
PENNY INCREMENT OFFSET
U. 00 This represents the penny increment price offset
used in Generation 2 (Enhanced Debit)
Non-Coin / Card-Ready Models. Choose from
0–4 pennies by pressing the WHITES AND
COLORS button.
■
Press the PERM. PRESS button once to
advance to next code.
END of SETUP PROCEDURES
EXIT FROM SETUP MODE
Stacked Models: Turn access panel key back to original
position.
DIAGNOSTIC GUIDE
If the setup mode is entered and one of the following has occurred,
the appropriate diagnostic code will be in the display.
STACKED DRYERS
CODE EXPLANATION
d1 Invalid upper dryer door circuit
state – The CSP Venus control
does not differentiate between
invalid state and open door state.
d4 The CSP Venus control will
send this error when the upper
motor feedback circuit is sensing
voltage with the door open or
when the motor should not be
on. The control does not know
if the relay is bad (stuck on), the
relay drive circuit is bad (shorted
causing the motor relay to stay
on), or the relay fedback circuit
is bad.
d9 Low voltage.
d12 Upper dryer motor sense circuit
error on control board or due to
power line interference (upper
dryer cycles and upper dryer
display disabled until diagnostic
code is manually cleared).
d13 Coin 2 failure.
d16 Gen 2 debit card communication
error.
d17 Lower dryer door sense error on
control board or due to power
line interference (lower dryer
cycles and lower dryer display
disabled until diagnostic code is
manually cleared).
d20 Lower dryer motor control circuit
error (upper dryer cycles and
upper dryer display disabled
until diagnostic code is manually
cleared).