Installation Instruction

Table Of Contents

ELECTRIC DRYER ELECTRICAL CONNECTIONS

Connecting 3-Wire Connection: Direct Wire

Use where local codes permit connecting cabinet-ground

conductor to neutral wire.

Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer

can be moved if needed.

Strip 3⁄" (89 mm) of outer covering from end of cable. Strip

insulation back 1" (25 mm). If using 3-wire cable with ground wire,

cut bare wire even with outer covering. Shape ends of wires into a

hook shape.

Connecting Neutral Wire

1. Loosen or remove center terminal block screw (A).

2. Place hooked end (hook facing right) of neutral wire (white or

center wire) (D) cable under center terminal block screw (B).

Squeeze hooked end together. Tighten screw.

3. Place hooked ends of remaining direct wire cables (hooks facing

right). Squeeze hooded ends together and tighten screws.

Finally, re-install terminal block cover and tighten hold-down

screw. Tighten screws. Go to “Complete Installation” section.

Connecting 3-Wire Connection: Optional

Use for direct wire or power supply cord where local codes

do not permit connecting cabinet-ground conductor to

neutral wire.

Connecting Neutral Wire

1. Remove center terminal block screw (A). Also remove neutral

ground wire (B) by removing external ground conductor

screw (C).

2. Connect neutral ground wire (B) and neutral wire (white or

center) (D) of power supply cord/cable under center terminal

block. Tighten screw.

3. Connect remaining wires under outer terminal block. Tighten

screws.

4. Connect a separate copper ground wire (G) under the external

ground conductor to screw (C) an adequate ground. Finally,

re-install terminal block cover and tighten hold-down screw.

Go to “Complete Installation” section.