Installation manual

24(]Edwar6sStreet.SE
C!eve[an_,Tennessee37311
Te_:J22-472-3333
Fax:423-,,t'7_,-_710
2. FROM LP GAS TO NATURAL GAS:
a.Place burner wrench (part number 8002P026-60, available from you dealer or authorized
service agency) over surface burner assembly with ignitor positioned inside gap in wrench
ring (figure 13A). This prevents ignitor from being crushed when wrench tightens on burner
assembly. Rotate burner assembly approximately one-eighth turn counter-clockwise and lift
from top (figure 13B). Using a 1/2" deep-well socket, loosen each burner orifice hood
approximately two complete turns counter-clockwise. Replace burner assembly in main top
and rotate one-eighth turn clockwise using burner wrench until burner locks into position
with ignitor facing rearward.
b. On ranges, use the 1/2" open end wrench to loosen the oven orifice hood (1-figure 18)
approximately tow complete turns counter-clockwise until the flames on the burner do not
increase in length. See figure 14A.
e. Adjust burner air shutter to the widest opening that will not cause the flame to lift or blow
off the burner when cold.
NOTE: Correctly adjusted sealed burners will blow off without a pot over the burner.
These should be adjusted with a pot in place.
ORIFICE OItlFIC._
HO00 HOOD
RGURE 14A FIGURE 14B
NATURAL GAS LP GAS
S_"iIING S z'"J'1ING
"..,7-." .,.,
_ JL_L_G ACm, ir-3t _'1 .;,,,,_.L_..:E."4N-,,_ ,¢ '*'da,,;jc ¢,,_f