Installation manual

240E(;war_sStreet,SE
C',eveiand,Tannessee37311
Tel:423-472-_333
Fax:_23-._78-_71D
SECTION 1
INSTALLATION
A. SERVICE - PARTS INFO1LMATION
WHEN YOUR RANGE REQUIRES SERVICE OR REPLACEMENT PARTS, CON-
TACT YOUR DEALER OR AUTHORIZED SERVICE AGENCY. PLEASE GIVE
THE COMPLETE MODEL AND SERIAL NUMBERS OF THE RANGE WHICH IS
LOCATED ON THE RANGE MODEL NUMBER PLATE. NOTE: THE RANGE
MODEL NUMBER PLATE IS LOCATED ON THE LOWER FRONT FRAME OF
THE RANGE.
B. CODES.
These units must be installed to conform with all local codes, rules and regulations including
municipal, provincial and state building codes, as well as local utility regulations. Ranges
approved for Canada will have the Canadian Gas Association (CGA) approval seal on the
model number plate. Ranges approved for Canada have been tested to insure compliance
with CGA 1.1.
ELECTR/C SUPPLY
The range must be installed in accordance with Local and National Electric Code (NEC)
ANSI/NFPA No. 70-1987.
In Canada the range must be installed in accordance with the current CSA Standard C22.1-
Canadian Electrical Code Part 1.
GAS SUPPLY
Installation of this range must conform with local codes or, in the absence of local codes,
with the National Fuel Gas Code, ANSIZ223.1-1988.
In Canada the range must be installed in accordance with the current CGA Standard
CAN/CGA-B149-Installation Codes tbr Gas Burning Appliances and Equipment and/or local
codes.
Check the range model number plate to see if the range is approved for installation in mobile
homes and/or recreational vehicles. If approved the following items are applicable.