Installation manual

CustomerSer',rica __
248EdwardsStreet,SE
C]e,:e]and.Tennessae37311
Te;::;23-472-,3.333
Fax:[phone];0
MOBILE HOMES
The installation of a range designed for mobile home installation must conform with the
Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly
the Federal Standard for Mobile Home Construction and Safety, Tide 24 HUD, Part 280) or,
when such standard is not applicable, the Standard for Manufactured Home Installations 1982
(Manufactured Home Sites, Communities and Set-Ups), ANSIA225. i-t984, or with local
codes.
In Canada, the range must be installed in accordance with the current CSA Standard
C22.1-Canadian Electrical Code Part 1 and Section Z240.4.1-Installation Requirements for
Gas Burning Appliances in Mobile Homes (CSA Standard CAN/CSA -Z240MH).
RECREATIONAL VEHICLES
The installation of a range designed for recreational vehicles must conform with state or other
codes or, in the absence of such codes, with the Standard for Recreational Vehicles, ANSI
A119.2-1982.
In Canada the range must he installed in accordance with Section C22.2 No.
148/CAN/CSA-Z240.6.2-Electrical Requirements for R.V. 's (CSA Standard CAN/CSE-
Z240RV Series) and Section Z240.4.2-Installation Requirements for Propane Appliances and
Equipment in R.V.'s (CSA Standard CAN/CSA-Z240 RV Series.
C. CLEARANCE DIMENSIONS
(See back page for installation drawings). All free-standing ranges can be installed with the
back against a vertical combustible wail, and the sides below the cooking surface against
combustible base cabinets. Slide-in ranges must be installed in accordance with figure 10C.
For complete information in regard to the installation of wail cabinets above the range and
clearances to combustible wails above the cooking top see the installation drawings (back
pages) and/or the Model Number Plate on the range. For SAFETY CONSIDERATIONS do
not install a'range in any combustible cabinetry which is not in accord with the installation
drawings and the clearance given on the range Model Number Plate.
CAUTION: DO NOT LIFT OR MOVE RANGE BY DOOR HANDLES, OR BACK-
GUARD.
D. LOCATING THE RANGE.
Do not set range over holes in the floor or other locations where it may be subject to strong
drafts. Any opening in the wall behind the range and in the floor under the range should be
sealed. Make sure the flow of combustion or ventilation air is not obstructed.
Be certain all packing materials are removed from the range before operating to prevent fire
tt_._I,A"tTAG _l_mll'al 71 _,.,ilEi_lN.,i'tlll "_"iafk: e,"tt