Installation manual

_ustomerService ..__
240_c.wardsStreet.SE
CleveJand.Tennessee3731
Tei:a22-_.72-3333
Fax:a23-478-_0
available). Secure the ANTI-TIP bracket to the floor with the two screws provided. Proceed
to Step 3.
2. Wall: Locate the center of the two holes identified in figure I as "WALL-PLATE'.
Drill an angled 1/8" pilot hole in the center of each hole as shown in figure 2. (A nail or awl
may be used if a drill is not available). Secure the ANTI-TIP bracket to the wail with the
two screws provided as shown in figure 2. Proceed to STEP 3.
B. Cement or Concrete Construction:
i. Suitable screws for concrete construction can be obtained at the hardware store. Drill the
required size hole for the hardware obtained into the concrete at the center of the holes iden-
tiffed in figure 1 as "FLOOR-CEMENT". Secure the ANTI-TIP bracket to the floor.
Proceed to STEP 3.
Step 3 - Range Installation
A. Complete the installation of the range per the installation instructions provided with the
product.
B. Align the range to its designated location and slide it back into position. Note: A mini-
mum clearance of 1/4" is required between the range and the leveling foot that will engage
the ANTI-TIP bracket, see figure 2.
C. For SAFETY CONSIDERATIONS as well as optimum performance adjust the range so
that it is level. This may be checked by placing a spirit level or a large pan of water on the
cooktop or the oven rack. If an adjustment is required pull the range forward, tip the range
and rotate the leveling feet as required.
D. To check the range for proper installation of the anti-tip bracket: Use a flashlight and
look underneath the bottom of the range to see that one of the rear leveling legs is engaged in
the bracket slot.
E. Proceed with the remainder of the instailation instructions provided with the range.