Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesCWR 610

FIRST AND ROUTINE WASHES

BEFORE USING THE APPLIANCE FOR THE FIRST TIME:

• IMPORTANT:

1. MAKE SURE YOU HAVE READ THE INSTALLATION INSTRUCTIONS.

2. REMOVE THE TRANSIT SCREWS AND TRANSIT BAR BEFORE USING THE

MACHINE FOR THE FIRST TIME.

• First wash cycle without laundry:

Open the tap.

Close the door.

Pour a little detergent (about 30 ml) into the detergent compartment .

Select a short wash programme (see programme chart).

Switch on the appliance.

This will remove any water remaining in the machine from the manufacturer's test run.

ROUTINE WASHES:

Open the tap.

Sort the laundry according to fabric type and colour and load the machine (see “Sorting

the wash”).

Close the door.

Add detergent and any additives required (see “Detergent and additives”).

Select the programme, temperature and special options

(see programme chart).

Make sure to meet exactly the starting point of the programme. Otherwise the first part

of the programme will not be executed: washing results will not be as good as after a

complete programme cycle.

Switch on the appliance.

00139gb.fm5 Page 15 Friday, September 15, 2000 4:27 PM

Summary of content (13 pages)

PAGE 1
00139gb.fm5 Page 15 Friday, September 15, 2000 4:27 PM FIRST AND ROUTINE WASHES GB BEFORE USING THE APPLIANCE FOR THE FIRST TIME: • IMPORTANT: 1. MAKE SURE YOU HAVE READ THE INSTALLATION INSTRUCTIONS. 2. REMOVE THE TRANSIT SCREWS AND TRANSIT BAR BEFORE USING THE MACHINE FOR THE FIRST TIME. • First wash cycle without laundry: 1. 2. 3. 4. 5. Open the tap. Close the door. Pour a little detergent (about 30 ml) into the detergent compartment . Select a short wash programme (see programme chart).
PAGE 2
00139gb.
PAGE 3
00139gb.fm5 Page 17 Friday, September 15, 2000 4:27 PM APPLIANCE AND ACCESSORIES 1. Worktop 2. Control panel 3. Detergent drawer 4. After-Sales Service sticker (inside door) 5. Door 6. Door handle - To open: pull handle - To lock: press the door firmly (the lock will click into place) 7. Filter (inside compartment door).
PAGE 4
00139gb.fm5 Page 18 Friday, September 15, 2000 4:27 PM . INSTALLATION TRANSIT SCREWS A The appliance is fitted with two transit screws and a transit bar to prevent internal damage while it is being moved. Before using the appliance the transit screws and transit bar MUST be removed. The appliance is fitted with two screws and a transit bar. 1. Remove the black screw (A) with a screwdriver. B 2. Unscrew the screw (B) on the red transit bar with a screwdriver. 3.
PAGE 5
00139gb.fm5 Page 19 Friday, September 15, 2000 4:27 PM INSTALLATION DRAIN HOSE • Drain hose connection to water outlet. 1. Unhook the drain hose from the left clip; see arrow (A). Important: Do NOT loosen the drain hose connection; see arrow (B), otherwise there is the risk of leakage (danger of scalding with hot water) and the normal filling and draining functions of the machine cannot be guaranteed. 2.
PAGE 6
00139gb.fm5 Page 20 Friday, September 15, 2000 4:27 PM PROTECTING THE ENVIRONMENT • • Packing • Eco-tips The packaging is marked with the recycling symbol , signifying that it can be 100% recycled. - A full load (depending on the programme selected) gives the best energy and water consumption. - Laundry which is lightly to moderately soiled does not require a prewash. - Lightly soiled laundry should be washed at a low temperature or with a short programme.
PAGE 7
00139gb.fm5 Page 21 Friday, September 15, 2000 4:27 PM SORTING THE WASH 1. Sort the load according to: • Fabric type / care label symbol Cotton, mixed fibres, easy care/delicates, wool. • Colours Separate coloured and white articles. Wash new coloured articles separately. • Article size Washing articles of different sizes together improves wash efficiency and distributes the load better in the drum. • Fabric delicacy Wash delicates separately.
PAGE 8
00139gb.fm5 Page 22 Friday, September 15, 2000 4:27 PM DETERGENT AND ADDITIVES CHOOSING THE RIGHT DETERGENT STAIN REMOVAL The type of detergent depends on: • the type of fabric (cottons, synthetics, delicates, wool); Note: Use only specific detergents for washing wool. • colour; • wash temperature; • degree and type of soiling. • Note: • Whitish residues on dark fabrics are due to the insoluble detergents components in modern phosphate-free detergents.
PAGE 9
00139gb.fm5 Page 23 Friday, September 15, 2000 4:27 PM DETERGENT AND ADDITIVES FILLING THE DETERGENT AND ADDITIVES 1. Pull out the detergent drawer. 2. Filling the detergent. • Programmes with pre- and main wash. • Main wash programme without prewash. • Add fabric softeners and conditioners no further than the “MAX” mark printed on the chamber • Fill chlorine bleach only to the “MAX” mark. • Stain remover. • Water softener (water hardness 4). • Starching.
PAGE 10
00139gb.fm5 Page 24 Friday, September 15, 2000 4:27 PM LIQUID BLEACH (HYPOCHLORITE) 2. Pre-bleach method: Laundry with heavy stains may be PRE-BLEACHED in the machine prior to carrying out a normal wash programme. Proceed by diluting the bleach in approximately 1l water outside of the washing machine in a small container. For a machine with temperature selector: • Turn the programme selector to programme 4. • Turn the temperature selector to Min.
PAGE 11
00139gb.fm5 Page 25 Friday, September 15, 2000 4:27 PM DRAINING RESIDUAL WATER WHEN TO DRAIN RESIDUAL WATER If the filter needs to be cleaned during a programme. Note: Make sure that the water has cooled before draining. • When transporting or moving the machine. • If there is danger of freezing in the installation room. In this case the machine and the hoses should be drained after every wash. • 6. Wait until the flow stops. 7.
PAGE 12
00139gb.fm5 Page 26 Friday, September 15, 2000 4:27 PM CARE AND MAINTENANCE APPLIANCE EXTERIOR AND CONTROL PANEL 1 2 Clean using normal household detergent (do not use abrasive products). • Dry with a soft cloth. Do not use petrol or petroleum products to clean plastic parts. • DETERGENT DRAWER 1. Disengage the drawer by pressing down the release lever and extract it. 2. Remove the siphon from the softener compartment. 3. Wash all the parts under running water eventually using a soft sponge. 4.
PAGE 13
00139gb.fm5 Page 27 Friday, September 15, 2000 4:27 PM TROUBLESHOOTING GUIDE The appliance will not switch on. • Power plug properly inserted in mains socket? • Mains fuse OK? • Power failure? • Tap turned on? Is water coming through? • Door closed? • Programme selected? • Appliance switched on? No water or insufficient water supply. • Tap turned on completely? • Kink in water hose? • Water hose filter clogged? (See “Care and Maintenance”). • Water hose frozen up? Waste water not pumped out.