Instruction for Use

10
GB
Installation
Positioning the appliance
Place your dishwasher where you want to install it. The ap-
pliance can even be placed so that its sides or back panel
are side by side with furniture or up against the wall. The
dishwasher is provided with water supply and drain hoses,
which can be directed towards the left or right to facilitate
appropriate installation.
This dishwasher model can be built-in under the one
worktop, and it therefore comes provided with an assembly
kit complete with an instructions sheet.
Levelling
Once the appliance is positioned, adjust the feet by screw-
ing them in or out depending on how high you want it and
level it so that it is horizontal; however it must not be tilted
by more than 2° under any circumstances.
If the appliance is level, this will help ensure its correct op-
eration.
Cold water connection.
Connect the cold water supply hose to a 3/4 gas threaded
connection, taking care to screw it tightly onto the tap (see
figure 1).
If the water hoses are new or have been out of use for an
extended period of time, let the water run to make sure it is
clear and free of impurities before making the connection.
If this precaution is not taken, the water inlet could get
blocked, causing damage to your dishwasher.
Hot water connection
Your dishwasher can be supplied with hot water from the
mains supply (if you have a central heating system with ra-
diators) at a temperature of no more than 60°C.
In this case, the wash cycle time will be about 15 minutes
shorter and the wash will be slightly less effective.
The connection must be made to the hot water supply fol-
lowing the same procedures as those indicated for the cold
water connection.
Anti-flooding protection
Your dishwasher is provided with a system that stops the
supply of water in the event of a problem with the water
supply hose or leaks within the appliance, thus preventing
any damage from being caused to your home. If for any
reason the box (containing the electrical components) hap-
pens to get damaged, unplug the appliance from the elec-
tricity socket immediately. To guarantee that the anti-flood-
ing safety device operates properly, box "A", with the wa-
ter inlet hose, must be attached to the water supply tap
only as shown in the figure.
Under no circumstance
should the water supply
hose be cut as it contains
live electrical parts. If the
length of the hose is not
sufficient for proper con-
nection, replace the hose
with one which is long
enough. This hose is avail-
able upon request from
specialised retailers and
service centres.
Drain hose connection
Fit the drain pipe into a drain
line with a minimum diameter
of 4 cm or place it over the
sink, avoiding restricting or
bending it and using the spe-
cial plastic elbow provided (see
figure to the left). The free end
of the hose should be be-
tween 40 and 100 cm above
the ground and should not be
immersed in water.
Warning: the special plastic elbow should be fastened firmly
onto the wall to prevent the drain hose from moving and
allowing water to spill outside the drain.
Electrical connection
Plug the appliance into a socket provided with an efficient
earth connection (the system's earthing is a guarantee of
safety provided for by law), after having checked that the
mains voltage and frequency values correspond to those
stated on the rating plate located on the stainless steel inner
door of the appliance and that the electrical system to which
the dishwasher is connected is sized for the maximum cur-
rent indicated on said rating plate. If the power socket to
which the appliance is connected is not compatible with the
plug, replace it with a suitable plug rather than using adapt-
ers or multiple plugs as these could cause overheating or
burns.
If the electricity supply wire is damaged, we recommend
you contact authorised Technical Assistance service centres
exclusively for a replacement.
A
A
A
Fig.1