Instruction for Use

20
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
1. The appliance is not working.
•
Is there a power failure?
•
Is the plug properly inserted in the socket?
•
Is the double-pole switch on?
•
Has the fuse blown?
•
Is the power cord damaged?
•
Is the thermostat set to
0
(Stop)?
2. Temperature inside the compartments is
not low enough.
•
Is the door shut properly?
•
Is the appliance installed near a heat source?
•
Is the thermostat setting correct?
•
Are the air circulation grilles blocked?
3. Temperature inside the refrigerator
compartment is too low.
•
Is the thermostat setting correct?
4. Water collects at the bottom of the
refrigerator compartment.
•
Is the defrost water drain blocked?
5. The inside light is not working.
Perform the checks for problem 1, then:
•
Disconnect the appliance from the mains
power supply.
To inspect the bulb, refer to the instructions
and illustration on the attached table.
•
Check the bulb and if necessary replace it.
Replace using maximum 15W bulb.
6. Excessive frost build-up in the freezer
compartment
•
Is the door shut properly?
•
Is food obstructing proper door closure?
Notes:
• The front edge of the appliance may be
hot. This prevents the formation of
condensation and is not a defect.
• Gurgling and hissing noises due to
expansion in the refrigerant circuit are
normal.
•
Periodically clean air vents and the condenser at the rear
of the appliance with a vacuum cleaner or a brush.
•
Clean the outside using a soft cloth.
Prolonged disuse
1.
Empty the refrigerator.
2.
Disconnect the appliance from the power supply.
3.
Defrost and clean the interior.
4.
In the event of prolonged disuse, leave the door open to
prevent the formation of mould, odours and oxidation.
5.
Clean the appliance.
•
Clean the inside of the low temperature compartment
(where fitted) when defrosting.
•
Periodically clean the inside of the refrigerator
compartment with a sponge dampened in warm water
and/or neutral detergent. Rinse and dry with a soft cloth.
Do not use abrasive products.
•
Clean the outside with a soft damp cloth.
Do not use abrasive products, scourers, stain-removers
(e.g. acetone, trichloroethylene) or vinegar.
Replacing bulbs:
When replacing the bulb, proceed as follows:
•
Unplug the appliance from the mains
•
Squeeze the tabs on the sides of the lamp cover and
remove it.
•
Replace the bulb with a new one, maximum 15 W.
•
Put the lamp cover back on and wait 5 minutes before
plugging the appliance back into the mains.
6gb33042.fm Page 20 Friday, July 9, 2004 2:51 PM