Setup and user guide

4
Respect the care labels of your laundry; make sure that it is
appropriate for being treated in a dryer.
CARE LABELS
The dots indicate the temperature degree for drying the laundry.
Normal temperature
Reduced temperature
Do not tumble dry
EMPTY ALL POCKETS
Objects like coins or keys can damage your laundry as well as the
drum.
ADAPTING THE DRYER TO WATER CONDUCTIVITY
The drying results are aected by the conductivity of the water used
during washing. If, by modifyingthe available dryness levels (iron
dry; cupboard dry; extra dry), you are not satised withthe nal
drying results, you can adapt the water conductivity level. The dryer
comes with preset level 2. Choose between level 1 (most damp
results) and 5 (most dry results).
Press and hold the Programme button until the Conductivity
Adjustment symbol on the display blinks.
Turn the knob to adjust the level (1 –2 – 3 – 4 - 5).
Press the knob to conrm the selected level.
This operation is not needed for every drying cycle. Once the most
satisfying water conductivity level has been identied, you no
longer need to modify it.
Always dry a full load; this optimizes the relative energy
consumption. The maximum load sizes for the various programmes
are indicated in the programme chart.
To reduce the drying time, make sure that the laundry is spun with
the maximum possible spin speed of the wash programme. This
reduces the moisture content in the laundry.
HINTS AND TIPS
SAVING TIPS
Programme Load
(Kg)
Spin Speed
(rpm)
Humidity
(%)
Energy consumption
(kWh)
Drying Time (min)
ECO COTTON *
10
5
1000
1000
60
60
5.75
2.97
185
103
ECO COTTON
10
10
800
1400
70
50
6.53
5.18
204
165
COTTON IRON DRY
10
10
10
800
1000
1400
70
60
50
5.73
5.13
4.53
175
150
136
SYNTHETICS
CUPBOARD DRY
3.5 1000 40 1.44 46
CONSUMPTION DATA
Data can dier in your home, mainly depending on the moisture
content of the laundry load.
*Reference programmes for Energy Label / Regulation
392/2012/EU.
Values are based on the default programme setting, with clean
door and bottom lter. For consumer tests, the door lter and
bottom lter need to be cleaned after each cycle.
For tests according EN 61121, the appliance shall be installed using
direct drain (see INSTALLATION GUIDE). The water shall be
collected in an external container for proper measurement.
The energy consumption and drying time may dier from the values
above. They depend on the operation conditions in your home
(such as voltage uctuation, mixture of textiles, humidity of the
textiles after spinning, load volume).
The values are determined according to European Norm 61121 and
refer to the default programme setting; changing the setting also
impacts the consumption data.