Specifications

2-2
Installation Clearances
The location must be large enough to allow
the washer door to be fully opened.
Additional
spacing should be considered
for ease of installation and servicing. The
door opens more than 90°, and it is not re-
versible.
Additional
clearances might be required for
wall, door, and floor moldings.
Additional spacing of 1˝ (2.5
cm) on all
sides of the washer is recommended to re-
duce noise transfer
.
Companion appliance spacing should also
be considered.
W
asher Dimensions
•
•
•
•
•
Recommended
installation spacing for
custom undercounter installation
The
dimensions shown are for the recom-
mended spacing.
Custom undercounter installation -
W
asher only
Stack Kit
Are you planning to stack your washer and
dryer? To do so you will need to purchase a
Stack Kit.
T
o order, call the dealer from whom you pur-
chased
your dryer or refer to the “Assistance
or Service” section in the “Use & Care Guide.”
Ask for Part Number 8572546.
LOCATION REQUIREMENTS
Selecting the proper location for your washer
improves performance and minimizes noise
and possible washer “walk.”
The
washer can be installed under a custom
counter, or in a basement, laundry room, clos-
et, or recessed area. See “Drain System.”
Companion
appliance location requirements
should also be considered. Proper installation
is your responsibility.
You will need
A water heater set to deliver 120°F (49°C)
water to the washer
.
A grounded electrical outlet located with-
in 6 ft (1.8 m) of where the power cord is
attached to the back of the washer. See
“Electrical Requirements.”
Hot
and cold water faucets located within
4 ft (1.2 m) of the hot and cold water fill
valves, and water pressure of 20-100 psi
(137.9-689.6 kPa).
A
level floor with a maximum slope of
1˝(2.5 cm) under entire washer. Installing
the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is
not recommended.
A
sturdy and solid floor to support the
washer with a total weight (water and load)
of 400 lbs (180 kg).
Do
not operate your washer in temperatures
below 32°F (0°C). Some water can remain
in
the washer and can cause damage in low
temperatures.
•
•
•
•
•
50¹⁄4 "
(127.6 cm)
27"
(68.6 cm)
36"
(91.4 cm)
29¹⁄4 "
(74.3 cm)
1"
(2.5 cm)
1"
(2.5 cm)
36" min.
(91.4 cm)
27"
(68.6 cm)
2" (5 cm)