Specifications

3-9
Clean Washer
Use the Clean Washer cycle once a month to
keep the inside of your washer fresh and clean.
This cycle uses a higher water level in combi-
n
ation with liquid chlorine bleach to thoroughly
clean the inside of your washing machine. See
“Cleaning The Washer.”
IMPORTANT: Do not place garments or other
items in the washer during the Clean Washer
cycle. Use this cycle with an empty wash tub.
Rinse/Spin
U
se this cycle to get a rinse and spin only. This
cycle combines fast-speed tumbling and high-
speed spin. If desired, you can reduce the spin
speed by selecting the speed you want from
the SPIN SPEED modifier.
Rinse & Spin is useful for:
Loads that need rinsing only
.
Adding fabric softener to a load using the
fabric softener dispenser.
Drain/Spin
Use
this cycle to drain your washer or to drain
and spin your wash load. The spin speed is
preset to HIGH. If desired, you can reduce the
spin speed by selecting the speed you want
from the SPIN SPEED modifier.
NOTE: Loads of synthetics, delicate fabrics,
h
andwashables, and woolens should be
drained with no spin or low spin to avoid fabric
stress.
Soak
Use
the Soak cycle to help remove small spots
of set-in stains on fabrics. This cycle provides
a soak time with warm or cold water, followed
by drain. Extra water, a short tumbling phase
for equal distribution of the laundry, and a
soaking time without drum movement, to help
improve the removal of set-in stains. Drain
without spin assures gentle treatment, even
for delicate items.
•
•
NORMAL SOUNDS
As with any new product, you will hear sounds
that you are not accustomed to. You may hear
various sounds when the door is locked or
unlocked, and during the washing, rinsing, or
spinning process. Between changes in wash
actions, there will be momentary pauses. You
will hear water spraying and splashing during
the wash and rinse cycles. These new sounds
and pauses are part of normal washer opera-
tion. See “T
roubleshooting.”
OPTIONS AND MODIFIERS
You can customize your wash by adding op-
tions to your cycle selections. You can add or
change an option after starting a cycle anytime
before the selected option begins. Not all op-
tions are available with all cycles.
S
ee the “Laundry Guide” section for an
overview of possible options for each Wash
Cycle selection.
If
an option is available with a selected cycle,
the light for that option will illuminate when
selected.
If
an option is unavailable with a selected
cycle, there will be a short tone and the
light for that option will not illuminate when
selected.
Delay W
ash
Use this to begin the wash cycle later.
Select DELAY WASH until the desired time
(in hours) shows in the Estimated Time Re-
maining display
.
Select START. The countdown to the wash
cycle will show in the display window.
•
•
•
•
•