Specifications

4-14
7. To remove the door switch assembly:
a) Pull the bellows off the lip of the front
panel beside the door switch assem-
bly
just enough to access the switch
assembly.
b) Remove the two T-20 Torx screws
from the door switch assembly.
Door Switch
Assembly Screws
Pull Bellows
Off Lip Of
Panel
REMOVING THE DOOR SWITCH ASSEMBLY
AND THE BELLOWS
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console
(see page 4-2 for the procedures).
4.
Remove the lower front access panel
(see step 10 on page 4-11 for the proce-
dure).
5.
Open the washer door.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
6. Using a small screwdriver or a pair of
long-nosed pliers, pull the tension spring
on the retaining wire out from around
the front of the bellows, and remove the
wire.
Bellows
Door Switch
Assembly
Retaining Wire
Tension Spring
Retaining Wire