Specifications

6-6
ERROR HISTORY DISPLAY
When the press and hold entry method is used
and successfully completed:
The control will respond by turning on all
lights for 5 seconds. After 5 seconds all
lights should turn off and the most recent
error code is displayed.
All of the cycle lights will flash and the error
code will be displayed on the status lights.
•
•
T
he next most recent error code is to be
displayed.
If there is no error code to display, or is the
last one, then all lights should turn off for
0.5 seconds and then all turn on for 5 sec-
onds. At the end of 5 seconds the lights
will turn off and the control will advance to
the automated test.
•
•
Indication
Control Action
Actuators to
be Checked
Whirlpool
Duet Sport
Whirlpool
Duet Sport Ht
Rinse/Spin Rinse/Spin
Door locks.
Door lock system
Clean Washer Clean Washer Distribution system is
set to CLEAN position.
Fill by cold water inlet
valve (4 liters).
Dispenser motor
Dispenser contact
Cold water inlet valve
Delicate Delicate/Hand Wash Distribution system is
set to MW position.
Fill by hot water inlet
valve to Level_wash
Dispenser motor
Dispenser contact
Hot Water inlet valve
Pressure switch:
Level_wash
Quickwash Drum executes
reversing movement at
wash speed (30 sec).
Motor
Motor Contro
l (MCU)
Normal/Casual Drum executes
reversing movement at
wash speed (30 sec).
Heater (if equipped)
Motor
Motor Contro
l
(MCU)
Heavy Duty Drain pump is ON.
Drain pump
Whitest Whites
Quickwash
Normal/Casual
Heavy Duty
Whitest Whites Drum rotates
counter-clockwise and
will ramp to the
maximum speed.
Motor
Motor Control (MCU)
HISTORY OVERVIEW TEST PROGRAM