Specifications

6-7
MANUAL DIAGNOSTIC TEST
The washer must be empty and the control
must be in the OFF state before pressing the
touchpad sequence to start the test.
Starting the Test Mode
Close the door.
Select any one key (except PAUSE/
CANCEL) and follow the steps below,
using the same key (remember the key):
•
•
N
OTES:
Press the same key to advance to the next
failure code.
At the end of the procedure the program
will loop back to the beginning. This is a
continuous loop.
To cancel out of the Manual Test Mode
press PAUSE/CANCEL.
•
•
•
Press/
hold 4
sec’s.
Release
for 4
sec’s.
Press/
hold 4
sec’s.
Release
for 4
sec’s.
Press/
hold 4
sec’s.
Release
for 4
sec’s.
Press/
hold 4
sec’s.,
release
Exit Condition Control Action To be Checked
On completion
only
Door locks.
Door lock system
On key press or if
overfill level is
detected
Distribution system is set
to Main Wash
compartment.
Filling with both valves.
Dispenser Motor
Dispenser contact
Cold and Hot
Water Inlet Valve
Overfill level
On key press or if
overfill level
is detected
Distribution system is set
to Bleach compartment.
Filling only by the Hot
valve.
Dispenser Motor
Dispenser contact
Cold and Hot
Water Inlet Valve
Overfill Level
On key press or if
overfill level is
detected
Distribution system is set
to Fabric Softener
compartment.
Filling with both valves.
Dispenser Motor
Dispenser contact
Cold and Hot
Water Inlet Valve
Overfill Level
On key press or if
overfill level is
detected
Distribution system is set
to Bypass channel.
Filling only by the Cold
valve.
For model Duet Sport HT,
the Heater is on during fill
until Level
_
wash is acti -
vated (80 minutes max.)
Dispenser Motor
Dispenser contact
Cold Water Inlet
Valve
Overfill Level
Heater element
(if equipped)
On key press or
completion
Drum executes reversing
movement at wash speed
(10 min).
Motor
Motor Control
(MCU)
On key press or
completion
Drain Pump is on (4 min).
Drain Pump
On completion
only
Drain Pump is on (reach
Level_sud plus 10 sec).
Drain Pump
On key press or
completion
Drum rotates
counter-clockwise and
ramps up to maximum
speed.
Motor
Motor Control
(MCU)
On key press only
after rpm = 0 and
door is unlocked
Stop motor to 0 rpm. Door
unlocks.
Motor
Motor Control
(MCU)
Doorlock system
MANUAL OVERVIEW TEST
PROGRAM
Be sure to perform the Diagnostic Tests before
replacing the system components.