Installation Guide

W10726823A This Sheet Replaces Page Number 5 7/14
ICE MAKER COMPONENT GUIDE
Components
Remove the contents from the shipping carton and set them on a
table where they can be easily identified and located. Check all of
the components in the kit against the following list to help you
become familiar with them. When you identify a component,
place a check mark (✓) after it. The KEY numbers correspond to
the “Component Illustrations.”
IMPORTANT: When you remove the water valve and flexible
tubing from the plastic foam packing insert, do not remove the
tubing from the valve. It has been factory-installed and leak-
tested. Do not disturb the compression nut that connects the
tubing to the valve, or the valve may leak after you connect it to
the water supply.
Do not discard any of the packing material until you account for
all of the components. If you need to order a replacement part for
the ice maker, a replacement parts list is provided on Page 28.
* For installation In Side-By-Side models only.
** For installation In 14 to 19 cu.ft. Top Freezer Models.
*** For installation In 11 cu. ft Top Freezer Models only
(kit 24ECKMF).
**** For installation In 21 cu. ft Top Freezer Models.
*****For installation in 14 to 16 cu. ft Top Freezer Models.
(evap cover with integrated air tower).
Component Illustrations
KEY QTY. DESCRIPTION
1 1 Ice maker
2 1 Ice bucket
3 1 Ice bucket extension
4 1 Water valve with tubing
5 1 Fill tube
6 1 Fill tube 128 mm (all except ***)
71Gasket */** only
8 1 71.6 mm (short) extension tube **
9 1 123.0 mm (long) extension tube *
10 2 Ice maker clips *
11 2 Tubing clips
12 1 Metal water tube insert
13 1 Water valve tubing clamp
14 4 1/2" hex-head sheet-metal screws
15 2 1/2" hex-head machine screws
16 2 3/4" hex-head sheet screws
17 1 63.5 mm extension tube ****/*****
18 1 85.7 mm extension tube ***
19 1 Bracket fill tube ***
Evaporator Cover With
Integrated Air Tower
Evaporator Cover With
Separated Air Tower
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19