Troubleshooting guide

17
Refrigerator Section
The thermostat, air ducts and drinking water reservoir are all accessible from inside the refrigerator
section.
Removing the Drinking Water Reservoir
The drinking water reservoir (Fig. 21) is located at the bottom of the refrigerator section. NOTE: The
bottom shelf and vegetable crispers must be removed.
1. Depress the top tabs on the drinking water
reservoir cover.
2. Pull the top of the cover forward and
dislodge the bottom tabs.
3. Pull the cover up and out of the unit.
4. Remove the hex-head screw securing the
reservoir to the back wall of the refrigerator
section.
5. Pull the water supply and feed tubes from
their foamed in conduits and remove the
reservoir from the unit.
Accessing the Thermostat and Cold Air Control Damper
The thermostat and cold air control damper are located behind the control cover at the top of the
refrigerator section. (Fig. 22)
1. Remove the thermostat and control damper
knobs.
2. Remove the hex-head screw securing the
control cover bracket to the left side of the
refrigerator section.
3. Dislodge the four (4) tabs securing the
control cover to the top and back of the
refrigerator section.
Removing the Thermostat
1. Remove the two screws securing the
thermostat to the thermostat bracket.
(Fig. 23)
2. Remove the sealer material from the end
of the sensor well.
3. Carefully pull the temperature sensing tube
from the sensor well.
4. Remove the thermostat from the unit.
Fig. 21
Fig. 22
Fig. 23
RESERVOIR
COVER
DRINKING
WATER
RESERVOIR
KNOBS
BRACKET
SENSOR
WELL
THERMOSTAT
THERMOSTAT
BRACKET