Troubleshooting guide
4
1. Remove toe grille by
pulling forward at
each end.
2. Turn roller adjust-
ment screw(s) clock-
wise until unit is
firmly on all
roller(s). (
Fig. 6
)
3. If unit is not stable
due to uneven floor-
ing, use shims under
rear roller(s).
1. Remove toe grille by
pulling forward at
each end.
2. Turn roller adjust-
ment screw for the
door that is lower
clockwise.
3. Open and close both
doors to confirm
doors are aligned.
4. Repeat until doors
are aligned.
1. Turn roller adjust-
ment screw(s) coun-
terclockwise until
unit is firmly on all
rollers.
2. If unit is not stable
due to uneven floor-
ing, use shims under
rear rollers.
1. Remove top hinge
cover. Loosen top
hinge screws. (
Fig. 9
)
2. Adjust both doors so
tops are aligned and
gap is consistent
from top to bottom.
3. Tighten top hinge
screws and replace
the covers.
▲
▲
▲
YES
YES
YES
YES
NO
NO
NO
NO
▲
Replace Toe Grille.
Is Center Gap
Consistent from
Top to
Bottom?
(
Fig. 8
)
Is
Unit
Stable?
Are Tops of Doors
Aligned with Each
Other?
(Fig. 7)
Is
Unit
Stable?
Slide Unit
into
Final Location.
ALIGNMENT AND LEVELING PROCEDURES FLOW CHART
▲
▲
▲
▲
▲
▲
▲
▲
▲