Specifications

Removing the base grille...
-
-
To remove the grille:
r
METAL CLIPS
-I
SUPPORT TABS
1. Open the door.
2. Pull grille outwards as shown.
3. Do not remove Tech sheet fastened behind
grille.
Ice compartment door.. .
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap
into place.
3. Close the door
Pull the Ice compartment door panel out from the
bottom and slide it to the rear
Ice cube trays...
(Model ETZORK only)
If cubes are not used, they may shrink The mov-
rng cold air starts a slow evaporation. The longer
cubes are stored, the smaller they get.
Automatic ice maker...
If you have Model ET20RM with the automatic
ice maker accessory, or if you have Model ET20RK
and plan to add one later (Part No. ECKMF-831,
there are a few things you will want to know:
LOWER
SIGNAL
ARM TO
START IT
l The ON/OFF lever is a wire signal arm
Down...for making ice automatically.
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
To remove ice:
1. Hold tray at both ends.
2. Slightly twist.
l The dial or lever on the side of the ice maker
changes the size of the cubes.
l Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage CapaCitY
l It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l You will hear water running when ice maker is
working. You’ll hear ice fall into the bin. Don’t let
these sounds bother you.
l The ice maker will not operate until the freezer
IS cold enough to make ice. This can take
overnight.
l Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard
the first few batches of ice.
l If ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control to-
ward a higher number. Wait a day and, if neces-
sary, turn the Freezer Control toward A