Instruction for Use

36
OPERATING MODE DESCRIPTION
Operation Modes:
1. Selecting mode
Each time MODE button is pressed, the operation
mode is changed in sequence:
COOLING DRY FAN ONLY HEATING
Heating mode is not available for cooling only air
conditioners.
COOLING mode: used to cool your room to feel
cool and comfort in the hot season.
DRY mode: used to remove moisture to feel
comfort in a humid climate.
FAN ONLY mode: used to ventilate your room,
the air conditioner operates like a fan.
HEATING mode: used to heat your room to feel
warm in the cold season.
Note: In order to prevent cool air blowing, 2-5
minutes are necessary to preheat the indoor unit
at HEATING operation start. The indoor fan will
not work during preheating.
2. Setting fan speed
Each time the "FAN" button is pressed, the fan
speed is changed in sequence:
Auto High Medium Low
At "FAN ONLY" mode, only "High", "Medium" and
"Low" are available.
At "DRY" mode, Fan speed is set at "Auto"
automatically, "FAN" button is ineffective in this
case.
3. Setting temperature
Press once to raise temperature setting by 1
raise °C
Press once to lower temperature setting by 1
lower °C
Press these two button and hold consistently, you
can change the number quickly.
*Note: Heating mode is NOT available for
cooling only models.
4. Turning on
Press button, when the appliance receives
the signal, the RUNNING indicator of the indoor
unit lights up.
During mode changes wait a few seconds and
repeat the operation if the unit does not respond
at once.
When selection the heating operation, air flow will
start after 2-5 minutes.
Range of available set temperature
*HEATING, COOLING 18°C~32°C
DRY +/-7°C
FAN ONLY unable to set
4
1 2
3