Use& CareGuide Drain (EVllOCXW and EWSOFXW) UPRIGHT FREEZERS EV11OCXWEVl5OFXW EVl50NXW
Contents Important Safety Instructions. Cleaning Your Freezer. . .. Installing Your Freezer. .... Using Your Freezer . . . . .... Setting the temperature control . . Adjusting the temperature control . . . . Cooling freezer first . . . . . ..... The power saving control . . . . . . . . .. The trivet. . . . . . . . . ........ . The interior light . . . . . . . . . . The signal light. ......, . If You Need Service or Assistance. Whirlpool Domestic Freezer Warranty.............................
ImportantSafetyInstructions To reduce the risk of fire, electrical shock, or injury when using your freezer, follow basic precautions including the following: Read all instructions before using the freezer. l Child entrapment and suffocation are not problems of the past. Junked or abandoned freezers are still dangerous...even if they will “just sit in the garage a few days.” If you are getting rid of your old freezer, do it safely.
1. Plug it in Recommended Grounding Method A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord. Attach retaining clip, from literature pack inside the freezer, over power cord plug. See Electrical Requirements and Grounding Instruction Sheet in your Literature Package.
UsingYourFreezer The drawings in this book may vary slightly from your freezer model. They are designed to show the different features of all the models covered by this book. NOTE: Your model may not include all the features shown. Setting the temperature control l Turn control to the middle of the dial. This setting is designed to maintain the temperature at or near 0°F (- 176°C) under normal operating conditions. Adjusting the temperature control l Turn control to higher number for colder temperatures.
Using Your Freezer Continued The interior light Electrical Shock Hazard Before removing a light bulb, either unplug the freezer or disconnect the electricity leading to the freezer at the main power supply. Shock and injury can occur if electricity remains connected. Light shield To replace the light: 1. Disconnect freezer from power supply. 2. Remove the light shield from the side of the control panel. Depress the back of the shield to release the tabs, then pull away. 3.
If YouNeedServiceOrAssistance We suggestyou follow these five steps: 1. Before calling for assistance... Performance problems often result from little things you can find and fix yourself without tools of any kind. If electricity goes off: Learn how long power will be off by calling the power company. l If service is to be interrupted 24 hours or less, keep freezer closed. Most food will stay frozen. l If service is to be interrupted longer than 24 hours, do this: 1.
FZOO2 LENGTH OF WARRANTY WHIRLPOOL WILL PAY FOR FULL ONE YEAR WARRANTY From Date of Purchase FSPE replacement parts and repair labor to correct defects in materials or workmanship. FULL FIVE YEAR WARRANTY From Date of Purchase FSPE replacement parts and repair labor to correct defects in. materials or workmanship in the sealed refrigeration system. These parts are: 1. Compressor 2. Evaporator 3. Condenser 4. Drier 5. Connecting tubing WHIRLPOOL WILL NOT PAY FOR A. Service calls to: 1.
