NOI-FROST UPRIGHT FREEZER Model EV150NXK (I USC and Cara Guide Lock SignoF--, Light Model and Serial Number Plate Copy Your Model Number and Serial Number Here When you need service, or call with a question, have this information ready: 1. Complete Model and Serial Numbers [from the plate just above base grille]. 2. Purchase date from sales slip, Copy this information in these spaces. Keep this book, your warranty and sales slip together in a handy place.
Before you plug it in Before using your freezer, you are personally responsible for making sure that it... l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use. l is connected only to the right kind of outlet, with the right electrical supply and grounding. 0 is used only for jobs expected of home freezers. l is not near an oven, radiator or other heat source Install l l l l l l Properly... is prc:perly maintained. is in C.Idry sheltered place.
. Using your freezer Setting Exterior Signal light... automatically failure. the Cold Control... warns of any unexpected power To start, turn control to the middle of the dial. This setting will maintain zero zone temperatures under normal operating conditions. Adjusting l l l .. . If the signal light is not glowing, immediately check: 0 for power interruption, l the power cord; it may be disconnected from the outlet, l the signal light; it may be burned out.
The Key Eject lock... can help entra bment. reduce Chanlging the hazard of To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock. If the key is lost, contact your WHIRLPOOL dealer for a replacement. Always give the complete model and serial number of your freezer when requesting a replacement key. Freezer light Bulb... child Shelves... 1. Unplhrg power cord. 2.
Cleaning your freezer This freezer is a No-Frost model and defrosts automatically. Complete cleaning, however, should be done at least once a year. To clean: 1, Turn Cold Control to OFF. 2. Unplug power cord. 3. Remove food. 4. Rer-love shelves and trivet. 5. Clel.:ln freezer according to the following dire::tions. After cleaning: 1. Replace shelves and trivet. 2. Plug in power cord. 3.
Freezing food in your freezer n one-third longer than distance around food to be wrapped. Place wrapping sheet on flat surface with food in center of sheet. When freezer has cooled to a safe storage temperature, it may be loaded with frozen food. When you plan to freeze unfrozen food, see the following chart for the amount to freeze at one time. 2. Hring front and back of wrapping together and fold in toward food, making at least two one-inch (2.5 cm] folds until food fits tightly against wrapping.
3. Add more unfrozen food after first load is frozen (approximately 18 to 24 hours). 4. After all food is frozen, return Cold Control to the usual selling. Storing Vacation and - l l-lo& AT frozen food . . . After food is frozen, stack packages anywhere in the freezer. Packages should not extend beyond the shelf edge or they may keep the door from closing and sealing properly. Vacations...
l l If service is to be interrupted longer than 24 hours, do this: 1. Remove all frozen food and store in a frozen food locker. Or... 2. Place dry ice on top of food, using as large pieces as possible. Protect your hands with gloves when using dry ice. 3. If neither food locker storage or dry ice is available, use or can perishable food at once. The length oftime food will stay frozen depends on several factors. For instance: a full freezer will remain cold longerthan a freezer only partially filled.