DRYER
Before you start... Mark an X across the letter or number as you complete each step. lnsfallation is adequate and I” conformance with the National Electrical Code ANSI/NFPA 70.latest edition. and all local codes and ordinances. R~~eplacle (IO-30Rl Typical 30-ampere receptacle for use where local codes permit J-Wire reCepKX3e use of flexible power supply Figure cord [pigtail). 2. THE DRYER MUST BE CONNECTED WITH 10.GAUGE COPPER WIRE ONLY You need these tcols to install your Whirlpool electric drver.
If local codes DO NOT permit cabinet grounding to the I neutral wire of lhe power supply cord: 2. Attach a %/d:U.L.-listed strain relref (U.L.marked on it) to the dryer through the power supply cord hole See Figure 4. Tighten strain relief firmly to cabinet. Place the power supply cord or direct wire through the strain relief. 3. Remove the grounding wire [green) from the external grounding connector and fasten under center silver-colored terminal block screw See Figure 7.
-. Now start... ’ 2 Open dryer and remove the ports packages. (If your dryer has a drying rack it should be removed also.) Remove all parts from the plostrc packages. Line these up next to your tools so each part is there when you need it Check to see that you have these parts: 3 Remove the tape n that holds the drum to the cabinet [Some dryer drums ore not loped for shipping.
when movie your dyer... : “. .shutosfeiectflcsuppiytodryer. It dryer does not operate Pw=b ifdryerwiiinotoperate.checkthe foiiowlng to be sure that: A. Eie&ic supply is ccnnected. B. Fuse is intact and tight. c.Doorisclosed. D. Controis are set in a running or “on”pdtion. E.Startbuttonhasbeenpushed firmly or the power coniroi level moved upward to start. Disunneg electrical c&and., tapeseagelybdryer. ‘zj.***ll Tapethi3dfumtothefrcntpanei. l Tapedryerdocxandiintxzeen.. l Screw le&iin~ legs ail fhe way in.