Instructions for use WASHER-DRYER ! This symbol reminds you to read this instruction manual.
Installation GB ! Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washerdryer to inform the new owner as to its operation and features. ! Read these instructions carefully: they contain vital information on installation, use and safety. Unpacking and levelling Unpacking ! This is a separate part of the polystyrene base and should be removed with the base.
Connecting the drain hose 65 - 100 cm Where it connects to the waste water pipe cut end off spigot or remove the blanking cap Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; The drain hose may be connected to an under-sink trap. Before connecting the drain hose from the machine ensure that any blanks or removable ends have been taken off the spigot.
GB As the colours of the wires in the lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked E or or coloured Green or Green & Yellow. Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board.
GB Technical data Model Dimensions Capacity Electrical connections Water connections Spin speed Energy rated programmes according to regulation EN 50229 FDD 9640 width 59.5 cm height 85 cm depth 54 cm from 1 to 9 kg for the wash programme from 1 to 6 kg for the drying programme please refer to the technical data plate fixed to the machine maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.
Care and maintenance GB Cutting off the water and electricity supplies Caring for the door and drum of your appliance • Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the washer-dryer and help to prevent leaks. • Always leave the porthole door ajar in order to prevent unpleasant odours from forming. • Unplug the washer-dryer when cleaning it and during all maintenance work.
Precautions and tips ! This washer-dryer was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully.
Description of the washer-dryer GB Control panel CLEANING ACTION ON/OFF button button DRYING button DISPLAY Detergent dispenser drawer WASH CYCLE SELECTOR START/PAUSE MYCYCLE button button with indicator light FUNCTION buttons buttons DELAY ANTI ALLERGY RINSE button button TEMPERATURE button CHILD LOCK button Detergent dispenser drawer: used to dispense detergents and washing additives (see “Detergents and laundry”).
Display GB Z B A X D C E Y F The display is useful when programming the machine and provides a great deal of information. The upper two strings A and B are used to display the selected wash cycle or the type of drying selected, the current wash cycle phase (the selected dryness level or drying time) and all the indications relating to the progress status of the cycle.
How to run a wash cycle or a drying cycle GB 1. SWITCH THE MACHINE ON. Press the On/Off button ; the text POWER ON will appear on the display and the START/PAUSE indicator light will flash slowly in a green colour. 2. LOAD THE LAUNDRY. Open the porthole door. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes on the following page. 3. MEASURE OUT THE DETERGENT.
Wash cycles and functions Max. temp. (°C) Description of the wash cycle Max. speed (rpm) Drying Wash cycles Table of wash cycles Detergents Max. Cycle load Fabric Wash softener (kg) duration CLEAN Plus 1 White (Whites): heavily soiled whites and delicate colours. 3 Synthetics (Synths Resistant) (3): lightly soiled delicate colours. 9 9 1400 9 40° (Max.
Detergents and laundry GB Detergent dispenser drawer Good washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause a build up on the inside of your appliance and contribute to environmental pollution. ! Do not use hand washing detergents because these create too much foam. A B 2 * 1 Open the detergent dispenser drawer and pour in the detergent or washing additive, as follows.
Troubleshooting Your washer-dryer could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be solved easily using the following list. GB Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. • There is no power to the socket, or the fuse has blown in the mains plug. The wash cycle does not start. • • • • • • The machine does not dry.
GB The machine vibrates a lot during the spin cycle. • The feet have not been adjusted, enabling the machine to rock. • New Installation - Either the Transit Bolts including the plastic spacers, or the Polystyrene Packaging have not been removed when installing the machine. • The machine is trapped between cabinets and/or walls. • The load is in a slight out of balance condition and machine is spinning, but at a lower speed. The machine is noisy.
Product Guarantee and Repair Information Guarantee 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase.
195153359.00 01/2017 GB Whirlpool EMEA S.p.A. via Carlo Pisacane n.1, 20016 Pero (MI) Italy www.hotpoint.co.