Instruction for Use

GB
29
! If the oven is too hot, the pyrolytic cycle may not start.
Wait for the oven to cool down.
! The programme may only be started once the oven door
has been closed.
To activate the Fast Clean programme:
1. Switch the control panel on by pressing the button.
2. Press the button; the TIME display will show the default
duration of 1:30 h (normal cycle), while he TEMPERATURE
display will show “Piro” and “nor” alternately;
3. The desired cleaning level can be selected by pressing
the button, then:
- pressing “ ” to switch to the intensive cycle: the duration
is 2 h and the TEMPERATURE display shows the text “Piro”
and “int” alternately;
- pressing “ ” to switch to the economy cycle: the duration
is 1 h and the TEMPERATURE display shows the text “Piro”
and “eco” alternately.
Safety devices
• the door locks automatically as soon as the temperature
reaches a high value; the icon lights up on the
display;
• pressing the button cancels the cleaning cycle t any
time;
• if a malfunction occurs, the heating elements will be
switched off;
• once the oven door has been locked, you cannot change
the duration and end time settings.
Problem
Possible cause
Solution
The appliance has just been
connected to the electricity mains
or there has been a blackout.
Set the clock.
A programmed cooking mode
does not start.
There has been a blackout. Reprogram the cooking mode.
Only the high luminosity
“Clock button” is lit.
The appliance is in standby mode Press any button to exit
standby mode.
The temperature inside the oven
is higher than the suggested
value for the selected mode.
Wait for the oven to cool down.
Fan-assisted cooking has been
selected and the food looks burnt.
Positions 1 and 5: the direct
heat could cause
temperature-sensitive
foods to burn.
We recommend switching
dripping pan positions halfway
through cooking.
The “Clock button” and the
digits on the display flash.
An automatic mode has been
selected. “Hot” appears on the
display and cooking does not
start.
Programming delayed automatic cleaning
! Programming is possible only after selecting the FAST
CLEAN mode.
1. Press the button and set the end time using
the “ ” and “ ” buttons.
2. Once you have reached the desired end time, press the
button again.
3. Press the button to activate the programmed mode.
4. When the selected time has elapsed, “END” appears on
the TEMPERATURE display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO)
FAST CLEAN level has been selected, with the default
duration of 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30 a.m.
The icons and ash to indicate that programming
has taken place. After programming, in the time before the
Fast Clean mode starts, the TIME display indicates the
duration and end of the Fast Clean mode alternately.
To cancel programming press the button.
Once the automatic cleaning cycle is over
Before you can open the oven door, you will have to wait
for the icon to switch off: this indicates the oven
temperature has dropped to an acceptable level. You will
notice some white dust deposits on the bottom and the sides
of your oven; remove these deposits with a damp sponge
once the oven has cooled down completely. Alternatively,
you can make use of the already heated oven, in which
case it is not necessary to remove the deposits, they are
completely harmless and will not affect your food in any way.
Troubleshooting