Mode d’emploi machine à laver
SOMMAIRE SECTION 1 : AVANT UTILISATION Consignes de sécurité Recommandations SECTION 2 : INSTALLATION Démontage des vis de bridage Réglage des pieds Raccordement électrique Raccordement du tuyau d'arrivée d'eau Raccordement du tuyau de vidange SECTION 3 : SPECIFICATIONS TECHNIQUES SECTION 4 : BANDEAU DE COMMANDE SECTION 5 : LAVAGE Préparation du lavage SECTION 6 : ENTRETIEN ET NETTOYAGE Filtres des raccords d'arrivée d'eau Filtre de pompe de vidange Bac à produits Siphon d’assouplissant Carrosserie Tambo
SECTION 1 : AVANT UTILISATION CONSIGNES DE SECURITE N'utilisez jamais d'adaptateur multiprises ou de rallonge lectrique. N'utilisez pas de prise dont le cordon est endommagé ou fissuré. Si le câble électrique est endommagé, il doit impérativement être remplacé par un technicien agréé afin d’éviter tout risque d’électrocution. Ne retirez jamais une prise en tirant sur le cordon. Retirez la prise en la prenant avec la main. Ne branchez pas de prise en ayant les mains humides.
Retrait de l’emballage et vérification • Après avoir déballé le lave-linge, vérifiez qu’il n’a pas été endommagé pendant le transport. En cas de doute, n’utilisez pas la machine. Contactez le Service Après-vente ou votre revendeur local. • Assurez-vous que les accessoires et pièces fournies sont au complet. • Les matériaux d’emballage (sachets en plastique, éléments en polystyrène, etc.) doivent être tenus hors de portée des enfants, car ils constituent une source potentielle de danger.
RECOMMANDATIONS Une lessive ou un assouplissant qui reste longtemps au contact de l'air sèchera et collera au bac à produits. Pour éviter cet inconvénient, versez le détergent ou l'assouplissant dans le bac à produits juste avant de démarrer le lavage. Utilisez uniquement la fonction prélavage pour les vêtements très sales. Ne dépassez pas la capacité de charge maximale.
Equilibrez au moyen des pieds. Desserrez l'écrou de réglage en plastique (Fig.4). Effectuez le réglage en tournant les pieds vers le haut ou vers le bas (Fig.5) Une fois que la machine est équilibrée, serrez l'écrou de réglage en plastique en le tournant vers le haut. Ne placez jamais de cartons, de cales en bois ou d'éléments similaires sous la machine pour compenser des irrégularités de niveau du sol. Fig.4 Fig.
La pression d’eau de l’ordre de 0,1-1 Mpa qui s’écoule de votre robinet permettra à votre machine de fonctionner plus efficacement (une pression de 0,1 Mpa équivaut à un débit d’eau de plus de 8 litres par minute qui s’écoule d’un robinet entièrement ouvert) Une fois les branchements effectués, vérifiez l'absence de fuites au niveau des raccords en ouvrant entièrement le robinet. Vérifiez que le tuyau d'arrivée d'eau n'est pas plié, fissuré ou écrasé.
SECTION 3 : SPECIFICATIONS TECHNIQUES FL 5103 / FL 5123 Capacité de charge maximale (linge sec) (kg) Hauteur x Largeur x Profondeur (cm) Vitesse maximale d'essorage (tr/min) Pression d’eau admise pour l’installation 5 85 x 59,6 x 51 1000 / 1200 1 à 10 Bar Voir plaque signalétique Puissance max.
SECTION 4 : BANDEAU DE COMMANDE E D C A-Sélecteur de programme B-Sélecteur essorage C-Touche départ/pause D-Touches de fonction E-Voyant début de programme F-Fin de programme 8 F B A
SECTION 5 : LAVAGE Branchez la machine. Ouvrez le robinet d'arrivée d'eau. PREPARATION DU LAVAGE Tri du linge Triez votre linge en fonction de sa matière (coton, synthétique, délicat, laine, etc.), des températures de lavage et du degré de salissure. Séparez impérativement le linge blanc du linge de couleur. Lavez séparément le linge de couleur neuf car il risque de déteindre au premier lavage. Vérifiez que les poches de vos vêtements ne contiennent aucune pièce métallique.
Les détergents La quantité de détergent dépend des critères suivants : Votre consommation de lessive changera en fonction du degré de salissure de votre linge. Pour le linge légèrement sale, n'effectuez pas de prélavage et versez une petite quantité de détergent dans le compartiment n° 2 du bac à produits. Pour le linge très sale, sélectionnez un programme avec prélavage, versez ¼ de la dose de détergent dans le compartiment n° 1 du bac à produits et la quantité restante dans le compartiment n° 2.
SECTION 6 : ENTRETIEN ET NETTOYAGE Débranchez votre machine. Fermez le robinet d'arrivée d'eau. FILTRES DES RACCORDS D'ARRIVEE D'EAU Cette machine est équipée de 2 filtres au niveau du tuyau d'alimentation qui empêchent les impuretés et corps étrangers de pénétrer dans la machine. L’un est situé dans le raccord côté machine et l’autre au robinet (voir page 4 et 5). Si la machine n'est pas suffisamment alimentée en eau malgré l'ouverture du robinet, nettoyez ces filtres. Démontez le tuyau d'arrivée d'eau.
FILTRE DE POMPE DE VIDANGE Le filtre de vidange protège la pompe de vidange utilisée pour évacuer l'eau sale. Il empêche les saletés diverses de venir obstruer le corps de pompe et de la bloquer. Il est recommandé de nettoyer le filtre de vidange tous les 2 à 3 mois (suivant utilisation). Pour nettoyer le filtre de vidange : * Débranchez le câble d’alimentation électrique.
ATTENTION ! Risque de brûlure ! Laissez refroidir l'eau à l'intérieur de la pompe avant le nettoyage. BAC A PRODUITS Les lessives peuvent à la longue former des dépôts dans votre bac à produits ou le support du bac à produits. Pour nettoyer les dépôts, retirez de temps à autre le bac à produits et nettoyez-le à l'aide d'une vieille brosse à dents et à l'eau courante. Pour retirer votre bac à produits : Tirez le tiroir jusqu’au bout (fig.
SIPHON D’ASSOUPLISSANT Retirez le bac à produits. Enlevez le bouchon du siphon et nettoyez soigneusement les résidus d'assouplissant. Nettoyez et remettez le bouchon du siphon en place. Vérifiez qu'il est bien en place. CARROSSERIE Pour nettoyer la carrosserie de la machine, utilisez un détergent neutre et un chiffon humide. Veillez toujours utiliser des susceptibles d'abimer la surface extérieure de votre machine.
SECTION 7 : INFORMATIONS PRATIQUES Boissons alcoolisées : Lavez la tache à l'eau froide, puis tamponnez d'un mélange de glycérine et d'eau et rincez avec un mélange d'eau et de vinaigre. Cirage : Grattez légèrement la tache sans abîmer le tissu, frottez avec un détergent et rincez. Si la tache persiste, frottez avec 1 volume d'alcool pur (90 degrés) mélangé à 2 volumes d'eau, puis lavez à l'eau tiède.
Moisissure : Les taches de moisissure doivent être nettoyées aussi rapidement que possible. Lavez la tache avec un détergent. Si la tache persiste, tamponnez avec de l'eau oxygénée (proportion de 3 %). Encre : Faites couler de l'eau froide sur la tache jusqu'à ce que l'encre soit complètement diluée. Frottez ensuite avec de l'eau citronnée et un détergent, attendez 5 minutes puis lavez. Fruits : Etendez la partie tachée de votre linge sur un récipient et versez de l'eau froide sur la tache.
PROBLEME Votre machine ne démarre pas. CAUSE EVENTUELLE Elle est débranchée. Les fusibles sont défectueux. Il y a une panne de courant. Vous n'avez pas appuyé sur la touche marche/arrêt. Le sélecteur de programme est positionné sur I (arrêt). Le hublot est mal fermé. Votre machine ne se remplit pas d'eau. Le robinet d'arrivée d'eau est fermé. Le tuyau d'arrivée d'eau est plié. Le tuyau d'arrivée d'eau est bouché. Les filtres du raccord d'arrivée d'eau sont bouchés. Le hublot est mal fermé.
PROBLEME Votre machine vibre. CAUSE EVENTUELLE La machine contient une petite quantité de linge. Cela n'empêche pas la machine de fonctionner. Une quantité excessive de linge a été chargée dans la machine ou le linge est mal réparti. Ne dépassez pas la quantité recommandée de linge et répartissez correctement le linge dans la machine. La machine touche un objet dur. Evitez que la machine ne touche un mur ou des meubles. Vous avez utilisé trop de lessive. Appuyez sur la touche marche/arrêt.
PROBLEME CAUSE EVENTUELLE POUR Y REMEDIER Une quantité de linge supérieure à la capacité maximale a été chargée dans la machine. Ne dépassez pas la capacité de charge maximale de la machine. Votre eau est peut-être dure. Utilisez la quantité de lessive indiquée par le fabricant. Le linge est mal réparti dans la machine. Répartissez correctement le linge dans la machine. La machine vidange dès qu'elle est remplie. L'extrémité du tuyau de vidange est trop basse par rapport à la machine.
PROBLEME L'essorage ne démarre pas ou démarre tardivement. CAUSE EVENTUELLE POUR Y REMEDIER Ce n'est pas une panne. Le système de contrôle de la répartition de charge est peut-être en cours. Le système de contrôle de la répartition de charge procédera à une répartition plus équilibrée de votre linge. Dès que la répartition sera effectuée, l'essorage démarrera. Lors du prochain lavage, veillez à bien répartir votre linge dans la machine.
CODE D'ERREUR INDICATEUR D'ERREUR CAUSE EVENTUELLE POUR Y REMEDIER Ouvrez entièrement le robinet. Vérifiez si l'eau n'est pas coupée. Si le problème persiste, la machine s'arrêtera automatiquement après un certain délai. Débranchez la machine, fermez le robinet et contactez le service après-vente agréé le plus proche. Nettoyez le filtre de pompe de vidange. Si le problème persiste, contactez le service aprèsvente agréé le plus proche. (*) Err 02 Le voyant début de programme clignote.
CODE D'ERREUR INDICATEUR D'ERREUR Err 05 Le voyant marche/arrêt et le voyant fin de programme clignotent. Err 06 Le voyant début de programme et le voyant fin de programme clignotent. Err 07 Le voyant marche/arrêt,le voyants début de programme et fin de programme restent allumés en permanence. Err 08 Le voyant marche/arrêt, le voyant début de programme et le voyant fin de programme clignotent. Err 09 Les voyants début de programme et fin de programme restent allumés en permanence.
SECTION 10 : SYMBOLES INTERNATIONAUX TEXTILES Température de lavage Lavage interdit (lavage à la main) Repassage doux Repassage moyen Repassage fort Repassage interdit Pas de séchage en tambour Séchage étendu Sans repassage Séchage à plat Javel interdit Chlorage Symboles de nettoyage à sec. Les lettres indiquent le type de solvant à utiliser.
5019 311 02007 52014248