Setup and user guide
EN
9
This data may dier in your home due to changing
conditions in inlet water temperature, water pressure etc.
CONSUMPTION DATA
PROGRAMME
TEMPERATURE
(°C)
LOAD
(KG)
WATER
(L)
ENERGY
(KWH)
APPROXIMATE
PROGRAMME DURATION (H:MIN)
APPROXIMATE
REMAINING MOISTURE
CONTENT (%)
WITHOUT RAPID WITH RAPID
Mixed 40 7.0 67 0.50 01:00 00:55 55
Cotton 95 12.0 (max) 126 3.50 03:15 -- 55
Cotton 60 12.0 (max) 120 2.00 02:35 01:55 55
Cotton 40 12.0 (max) 94 1.70 03:30 02:10 55
Synthetics 60 4.0 58 1.20 02:20 01:20 35
Synthetics 40 4.0 55 0.80 02:20 01:20 35
ECO COTTON
60 12.0 (max) 63 0.51 06:00 04:00 53
ECO COTTON
60 6.0 43 0.46 04:00 * 53
ECO COTTON
40 6.0 43 0.43 04:00 * 53
Values measured in normal conditions in accordance
with IEC/EN 60456. Water, energy and remaining
moisture content values refer to the default setting of
the programmes, without options.
max = maximum load capacity of the washing machine
Acoustic values on declaration label refer to appliance
after complete installation, with adhesive pads xed on
bottom of washing machine according to separate
instructions.
* Duration indicated after load sensing
Eco Cotton is the standard programme for washing
normally soiled cottons, and it is the most ecient
programme in terms of combined water and energy
consumption. For reasons of energy saving,the real
water temperature may deviate from the specied cycle
temperature.
Power consumption in o-mode is 0.25W/in left-on
mode 0.25W.
Refer to the Programme Chart to check if options are
available for the selected programme
OPTIONS which are selectable by pressing the
Options button
Prewash
Helps to clean heavily soiled laundry by adding a
prewash phase to the wash programme selected.
Extends the programme by about 20minutes.
For adding detergent to the prewash phase
• automatically: make sure that the auto dosing system
is activated (see FUNCTIONS / Auto Dosing)
• manually: add the detergent portion for the prewash
phase directly to the drum in a detergent ball, before
starting the programme.
Hot Finish
The programme ends with a warm rinse phase.
This relaxes the bres of your laundry, and the
laundry feels comfortably warm when taking it
out a short time after programme end.
Bio Stains 15°
Helps to remove all kinds of stains, except
grease/oil.
The programme begins with a cold water
wash phase. Extends the programme by about
10minutes.
Pre-treatment recommended for stubborn stains.
Not selectable for Cotton 95°C.
Colours 15°
Helps to preserve the colours of your laundry
by washing it with cold water (15°C). Saves
energy for water heating, while keeping a
good wash result.
Suitable for lightly soiled coloured laundry without
stains.
• Make sure that your detergent is suitable for cold wash
temperatures (15 or 20°C).
• Not selectable for Cotton 95°.
Fresh Care
Helps to keep your laundry fresh if you cannot
unload it soon after programme end.
The washing machine will start to tumble the
laundry periodically a short time after
programme end. This tumbling will last up to
approximately 6 hours after end of your wash
programme. You can stop it at any time by pressing any
button; the door unlocks and you can take out your
laundry.
Heavy Soil
Helps to clean heavily soiled, stained laundry by
optimising the eciency of additives for stain
removal.
Add an appropriate amount of in-wash additive for stain
removal (powder) to the manual detergent dosing
compartment, together with your detergent (powder
only). May extend the programme by up to 15minutes.
Appropriate for use with oxygen-based stain removers
OPTIONS, FUNCTIONS AND INDICATORS