Installation guide
Cabinet Dimensions - Double Ovens
Double Ovens Installed in Cabinet
_A_
4
E
F
_D_
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 143/4'' (37.5 cm) bottom of
cutout to floor
D. 251/= '' (64.8 cm) cutout width
E. 11/='' (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 493/4 '' (126.4 cm) min. cutout
height
B
C
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 143/4'' (37.5 cm) bottom of
cutout to floor
D. 281/=" (72.4 cm) cutout width
E. 11/='' (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 493/4 '' (126.4 cm) min. cutout
height
Cabinet Side View - Single or Double Oven
D
/C
,/
A. 231/4'' (59.1 cm) min. cutout depth
B. 23" (58.4 cm) recessed oven depth
C. Qven front
D. Recessed oven
E. Cabinet
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path and the wire gauge are in accordance with local
codes.
Check with a qualified electrical installer if you are not sure the
oven is properly grounded.
This oven must be connected to a grounded metal, permanent
wiring system.
Be sure that the electrical connection and wire size are adequate
and in conformance with the National Electrical Code, ANSl/NFPA
70-latest edition or CSA Standards C22.1-94, Canadian Electrical
Code, Part 1 and C22.2 No. O-M91-1atest edition, and all local
codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
Electrical Connection
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
• Oven must be connected to the proper electrical voltage and
frequency as specified on the model/serial number rating
plate. The model/serial number rating plate is located at the
bottom of the right-hand mounting rail. See the following
illustrations.
A
Single Oven
A. Model/serial number plate
Double Oven
A. Model/serial number plate