Setup and user guide

ManualsBrandsWhirlpool ManualsDishwashersGBE 1B19 B

APPLIANCE

PRODUCT DESCRIPTION

1. Upper rack

2. Foldable aps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Cutlery basket

7. Lower spray arm

8. Filter Assembly

9. Salt reservoir

10. Detergent and Rinse Aid dispensers

11. Rating plate

12. Control panel

DAILY REFERENCE

GUIDE

CONTROL PANEL

Before using the appliance carefully read Health and Safety guide.

You can download the Safety Instructions and the Use and Care Guide, by visiting our

website docs.whirlpool.eu and following the Instructions on the back of this booklet.

0000 000 00000

Service:

1. Door handle

2. On-O/Reset button

3. Program selection knob

4. Indicator light Washing

5. Indicator light Drying

6. Indicator light Wash Cycle Complete

7. Start/Pause button and indicator light

8. Salt rell indicator light

4 5

6 8

2 3

Summary of content (8 pages)

PAGE 1
EN DAILY REFERENCE GUIDE You can download the Safety Instructions and the Use and Care Guide, by visiting our website docs.whirlpool.eu and following the Instructions on the back of this booklet. Before using the appliance carefully read Health and Safety guide. PRODUCT DESCRIPTION APPLIANCE 1 7 2 8 3 4 5 9 6 11 10 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
PAGE 2
FIRST TIME USE SALT, RINSE AID AND DETERGENT ADVICE REGARDING THE FIRST TIME USE After installation, remove the stoppers from the racks and the retaining elastic elements from the upper rack. FILLING THE RINSE AID DISPENSER Rinse aid makes dish DRYING easier. The rinse aid dispenser A should be filled when when the dark optical indicator on the dispenser door C becomes transparent.
PAGE 3
EN Drying phase PROGRAMS TABLE Program Detergent container Tub B Duration of wash program (h:min)*) Water consumption (litres/cycle) Energy consumption (kWh/cycle) 3:20 12.0 1.04 1 Eco 50° 2 Intensive 65° - 2:30 15.0 1.50 3 Normal 55° - 2:00 15.0 1.35 4 Rapid 40’ 50° - - 0:40 9.0 0.90 5 Pre-Wash - - - 0:10 4.5 0.01 ECO program data is measured under laboratory conditions according to European Standard EN 50242.
PAGE 4
DAILY USE 1. CHECK WATER CONNECTION Check that the dishwasher is connected to the water supply and that the tap is open. MODIFYING A RUNNING PROGRAM 3. LOAD THE RACKS (see LOADING THE RACKS) If a wrong program was selected, it is possible to change it, provided that it has only just begun: press and hold the ON/OFF button, the machine will switch off.
PAGE 5
EN LOADING THE RACKS UPPER RACK Load delicate and light dishes: glasses, cups, saucers, low salad bowls. LOWER RACK For pots, lids, plates, salad bowls, cutlery etc... Large plates and lids should ideally be placed at the sides to avoid interferences with the spray arm.
PAGE 6
CARE AND MAINTENANCE CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS Regularly clean the filter assembly so that the filters do not clog and that the waste water flows away correctly. The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water: to obtain the best washing results, you need to keep them clean. On occasions, food residue may become encrusted onto the spray arms and block the holes used to spray the water.
PAGE 7
EN TROUBLESHOOTING Your dishwasher may not work properly. Before contacting the Service Centre check if the problem can be solved by going through the following list. PROBLEMS POSSIBLE CAUSES SOLUTIONS The dishwasher won’t start or does not respond to commands. The appliance has not been plugged in properly. Insert the plug into the socket. Power outage. The dishwasher starts automatically when the power returns. The dishwasher door is not closed.
PAGE 8
400011308757 09/2018 as - Xerox Fabriano 8