Installation guide

ManualsBrandsWhirlpool ManualsConvection OvenGBS277PRQ00

INSTALLATIONINSTRUCTIONS

27" (68.6 CM) ELECTRICSINGLE AND DOUBLE

BUILT-IN OVEN

INSTRUCTIONSD'INSTALLATION

FOUR ELECTRIQUEENCASTRE27" (68,6 CM) -

SIMPLE ETDOUBLE

TableofContents/Tabledes mati@res

INSTALLATION REQUIREMENTS .................. 2

Tools and Parts .............................................. 2

Location Requirements .................................. 2

Electrical Requirements ................................. 4

INSTALLATION INSTRUCTIONS .................... 4

Prepare Oven for Installation ......................... 4

Remove Oven Trim ........................................ 4

Make Electrical Connection ........................... 5

Install Oven ..................................................... 7

Complete Installation ..................................... 8

SleCURITle DU FOUR ENCASTRle .................. 9

EXIGENCES D'INSTALLATION ..................... 10

Outillage et pieces ....................................... 10

Exigences d'emplacement .......................... t 0

Specifications _leotriques ............................ t 2

INSTRUCTIONS D'INSTALLATION .............. 12

Preparation du four pour I'installation ......... 12

D_pose des garnitures du four .................... 12

Raccordement _lectrique ............................ 13

Installation du four ....................................... 15

Achever I'installation .................................... 16

BUILT-INOVEN SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow

instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

_MPORTANT:

_nstaHer: Leave installation instructions with the homeowner.

Homeowner: Keep installation instructions for future reference.

Save installation instructions for local electrical inspector's use.

_MPORTANT :

_nstaHateur : Remettre les instructions d'installation au proprietaire.

Proprietaire : Conserver les instructions d'installation pour reference ulterieure.

Conserver les instructions d'installation pour consultation par Hnspecteur local des installations electriques.

8303648

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS 27" (68.6 CM) ELECTRICSINGLE AND DOUBLE BUILT-IN OVEN INSTRUCTIONS D'INSTALLATION FOUR ELECTRIQUEENCASTRE 27" (68,6 CM) SIMPLE ETDOUBLE TableofContents / Tabledes mati@res INSTALLATION REQUIREMENTS .................. 2 Tools and Parts .............................................. 2 Location Requirements .................................. 2 Electrical Requirements ................................. 4 INSTALLATION INSTRUCTIONS .................... 4 Prepare Oven for Installation ....
PAGE 2
INSTALLATIONREQUIREMENTS Product Dimensions - Single Oven Gather the required tools and parts before starting installation. Tools needed • Phillips screwdriver Parts needed • A UL listed or CSA approved conduit connector • ULlisted wire nuts Parts supplied • 2 screws (single oven) or 4 screws (double oven) Check local codes. Check existing electrical supply. See "Electrical Requirements." All electrical connections should be made by a licensed, qualified electrical installer.
PAGE 3
Single Oven Installed in Cabinet Installation Clearances - Double Oven _A Double Oven Installed in Cabinet B F F _D_ E E A. 27" (68.6 cm) min. cabinet width B. 1" (2.5 cm) top of cutout to bottom of upper cabinet door C. 32" (81.3 cm) bottom of cutout to floor D. 25'/2" (64.8 cm) cutout width E. 1V2"(3.8 cm) min. bottom of cutout to top of cabinet door F. 273/4``(70.5 cm) min. cutout height Product Dimensions - Double Oven C A. 27" (68.6 cm) min. cabinet width B. 1" (2.
PAGE 4
If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. Electrical Do not ground to a gas pipe. Check with a qualified electrical installer if you are not sure the oven is properly grounded. • Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate.
PAGE 5
3= Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Lift and pull oven door toward you and remove. Set the oven door aside on a protective surface. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge solid copper wire. 4. Electrically ground oven. Remove bottom screw on each side of the oven trim. Failure to follow these instructions fire, or electrical shock.
PAGE 6
4-Wire Cable from Power Supply 3-Wire Cable from Power Supply IMPORTANT: Use the 4-wire cable from power supply where local codes do not permit connecting the frame-ground conductor to the neutral (white) junction box wire or when connecting to a 4wire electrical system. IMPORTANT: Use the 3-wire cable from power supply where local codes permit connecting the frame-ground conductor to the neutral (white) junction box wire: A B ...................................... E C D A. Cable from power supply B.
PAGE 7
Liftovenintocabinet cutoutusingtheovenopening asan areatogrip. NOTE: Pushagainst sealareaofovenfrontframewhen pushing ovenintocabinet. Donotpushagainst outside edges. A. Mounting rail B. insert screw On some models, the oven vent is taped to the side of the oven. See following instructions to install. a}. Insert the vent tabs (B) into slots (A) in the oven frame. b}. With one screw (C) for each side of the vent, fasten vent securely to the oven.
PAGE 8
. Pusheachtrimintoplaceatbottomoftrim. 1. 2. 3. 4. 5. A. Push trim into place and replace screw 9. Use screws to attach each trim to oven. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. Check that you have all of your tools. Dispose of/recycle all packaging materials. For oven cleaning, see the "Oven Care" section of the Use and Care Guide. Read "Oven Use" in the oven Use and Care Guide. Check Operation of Single Oven 1.