COMPACTORS Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www.whirlpool.com In Canada, for assistance, installation or service, call: 1-800-807-6777 or visit our website at www.whirlpool.ca Table of Contents .................................................
TABLE OF CONTENTS COMPACTOR SAFETY ..................................................................2 INSTALLATION INSTRUCTIONS ..................................................3 Unpacking ....................................................................................3 Location Requirements................................................................3 Electrical Requirements ...............................................................4 Freestanding and Undercounter Installation ................
INSTALLATION INSTRUCTIONS Installer: Leave Use and Care Guide with the homeowner. Homeowner: Keep Use and Care Guide for future reference and for local electrical inspector’s use, if required. 13. Remove the shipping base from the bottom of the compactor. Unpacking A WARNING B Excessive Weight Hazard Use two or more people to move and install compactor. Failure to do so can result in back or other injury. A. Leveling legs B. Shipping base IMPORTANT: ■ Do not grasp console to move compactor.
Clearance Dimensions Freestanding and Undercounter Installation NOTE: Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the personal responsibility and obligation of the customer to contact a qualified installer to assure that electrical installation meets all national and local codes and ordinances. Tools Needed Gather the required tools and parts before starting installation. B A A. Leave 6" (15.
■ Undercounter Installation If the compactor is to be midway between “1” and “3,” place the retaining bracket mounting screws through “2.” NOTE: Installation hardware is not provided. See “Accessories” for ordering conversion kit. 1. Measure the height of your kitchen cabinet opening. The top of the compactor should be at least ¹ ₈" (3 mm) from the top of the kitchen cabinet opening. The rear wheels are preset for a kitchen cabinet opening height of 34¹⁄₄" (87 cm) (position 1).
14. Check to see whether drawer opens freely. If the toe plate rubs against floor, see “Adjusting the Toe Plate” for further instructions. Adjusting the Toe Plate If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows: 1. Mark on each side of the toe plate the amount of toe plate that rubs the floor covering. 2. Remove the drawer from the unit. See Step 3 in the “Unpacking” section. 3.
Installation 1. Remove the mounting screws attaching the foot pedal to the compactor. Remove foot pedal. 7. Reinstall the toe guard using the existing screws and ¹⁄₂" (13 mm) washer. Then, reinstall the foot pedal. B A A C A B C A. Mounting screws B. Foot pedal 2. Remove mounting screws attaching the toe guard to the compactor. Remove toe guard. 3. Remove the mounting screws attaching the decorative panel to the compactor. Remove decorative panel and discard mounting screws. 4.
2. Place trash in compactor. ■ Wrap or cover wet or messy trash. ■ Do not compact items that may develop offensive odors such as raw meat, fish, grapefruit rinds, disposable diapers, or personal hygiene items. ■ Load bottles or cans on their sides in the center of the drawer. Do not load bottles in an upright position. ■ Press START. The compactor will automatically stop at the end of the cycle. 2. To stop the compactor during a cycle: ■ Press OFF. 3. Close the drawer.
Installing a New Bag Do not use any kind of bag other than those designed especially for use in your compactor. Order replacement compactor bags through your local dealer or by calling the toll-free number on the cover or in the “Assistance or Service” section. IMPORTANT: Before installing a new bag, be sure: ■ The drawer side is securely locked. ■ 2. Lock bag in place by pulling the 4 prepunched holes over the bag retainer buttons. Holes will expand over the buttons without damaging the bag. 3.
NOTE: Look to see how the drawer rollers move in the tracks. It will be easier to replace the drawer after you have finished cleaning. 5. Wash the inside of the cabinet with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth. 6. To replace the drawer, grasp it by the sides and insert the rollers onto the tracks. 7. Lift the front of the drawer and push it in fully past the stops. Cleaning the Ram 2. Lift the front of the drawer to clear the stops.
ASSISTANCE OR SERVICE Before calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond to your request. If you need replacement parts If you need to order replacement parts, we recommend that you only use FSP® factory specified parts.
WHIRLPOOL® COMPACTOR WARRANTY ONE-YEAR FULL WARRANTY ON COMPACTOR For one year from the date of purchase, when this compactor is operated and maintained according to instructions attached to or ® furnished with the product, Whirlpool Corporation or Whirlpool Canada LP will pay for FSP factory specified parts and repair labor costs to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company.