Instruction for Use

10
If a fault occurs, before contacting our After-Sales Service, make the following
checks to try and remedy the problem.
Restart the wash programme to see if the
fault repeats.
If the malfunction persists, switch off the
appliance and turn off the water tap. Call our
After-Sales Service.
The appliance will not switch on:
•
Power plug properly inserted in the mains
socket?
•
Power failure?
•
Have you switched the dishwasher on or
have you pressed the On/Off push button?
Tap turned on? If not:
•
Turn on the water tap.
•
Make sure the water hose filter is not
clogged.
To do this, turn off the water tap, disconnect
the water hose, clean the filter, reconnect
the water hose to the tap and turn on the tap.
•
Door closed properly?
Crockery still dirty after washing:
•
Have you selected the correct programme?
•
Have you used the correct amount of
detergent?
•
Filters clogged or incorrectly assembled?
•
Spray arms blocked or nozzles clogged?
•
Salt container cap screwed down?
•
Crockery loaded correctly? (the water jets
must spray the entire surface of all items).
•
Filters clogged?
Crockery loaded upside down?
When loading large items in particular, make
sure the water circulates and does not collect
inside them.
Spotted crockery:
•
Water hardness duly checked and
regulated?
•
Salt container empty?
•
Insufficient detergent?
Spotted glasses and cutlery:
•
Too much rinse aid? (Adjust the rinse aid
regulator to a lower setting).
When the appliance will not be used for a
long period:
•
Run twice the “Pre-Rinse” programme.
•
Clean the filters.
•
Take the power plug out of its socket.
•
Leave the door ajar to prevent bad odours.
•
Close the water tap.
Upon re-use of the appliance please follow
the following procedure:
•
Open the water tap.
•
Reconnect the power plug to the socket.
Note:
On some models when the On/Off push button is
pressed, a pre-rinse cycle is performed prior to
the actual wash programme to regenerate the
water softener system.
Before contacting our After-Sales
Service:
1.
Try to remedy the problem (see
“Troubleshooting Guide”).
2.
Switch off the dishwasher and restart the
wash programme to see if the fault repeats.
If, after carrying out the above checks the
malfunction persists, call our After-Sales
Service and specify:
•
The nature of the
problem.
•
The appliance type
and model.
•
The service number
(the number after the
word Service on the
adhesive label)
located inside the
door on the right hand
side.
•
Your name, address and telephone number.
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE