Installation guide

14-30R Four-wire receptacle (required for mobile homes)
Direct wire cable must have
four feet of extra length so
dryer can be moved if needed+
Strip 5 inches of outer +covering
from end of cable+ Leave bare
ground wire at 5 inches. Cut
1+1/2 inches from 3 remaining
wires+ Strip insulation back
1 inch,
+r)
4. Remove center terminal block screw.
"X 5. Remove appliance ground wire (green
with yellow stripes) from external ground
connector screw. Fasten under center,
6. Connect the ground wire _ silver-colored terminal block screw.
(bare) of the power supply _ /
cable to the external ground __ _ /
conductor" screw. Tighten _' n n n d
screw, [ _ __ _Lr_
/ / . .... -, _ of the neutral wire (white
// _ _ or"center) of power
8. Place the hooked ends of the sy ' upply cable under the
other power supply cable wires center screw of terminal
under the outer terminal block block (hook facing right).
screws (hook facing right). Squeeze Squeeze hook end
hooked ends together. Tighten together: Tighten screw.
screws.
9. Tighten strain relief screws.
10, Insert tab of terminal block cover
into slot of dryer rear panel. Secure cover
with hold-down screw.
10-30R Three-wire receptacle
5o Connect the neutral wire (white
or center) of power supply cord to
the center, silver+colored terminal
screw of the terminal block.
Tighten screw.
6. Connect the other N
wires to outer terminal
k'
block screws. Tighten
screws.
7. Tighten strain relief
screws,
8, Insert tab of terminal block cover
into siot of dryer rear panel Secure
cover with hold-down screw,
HH++D+rectwirecablemusthave
four feet of extra length so
dryer can be moved if needed.
Strip 3-1/2 inches of outer
covering from end of cable,
Strip insulation back 1 inch. If
using 3-wire cable with
ground wire, cut bare wire
even with outer covering.
. wire
• (:enter)
WhereIota[ cedespermit
connecting cabinet=ground conductor to neutraJ wire:
4, Loosen or remove center terminal
block screw.
5. Place the hooked end of the \\
neutral wire (white or center)
power supply cable under the
center screw of the terminal
b!ock (hook facing right).
Squeeze hooked end together.
Tighten screw.
6. Place the hooked ends of
the other power supply cable
wires under the outer terminal ._ .... .,
block screws (hook facing , ,
right). Squeeze hooked ends
together. Tighten screws.
7, Tighten strain relief screws.
8. Insert tab of termina! block cover
into slot of dryer rear panel+ Secure
cover with hold-down screw.
Panel B