Use and care guide

10
EXTERIOR SURFACES
Clean surfaces with a damp microbre cloth. If they
are very dirty, add a few drops of pH-neutral deter-
gent. Finish o with a dry cloth. Do not use corrosive
or abrasive detergents. If any of these products inad-
vertently comes into contact with the surfaces of the
appliance, clean immediately with a damp microbre
cloth.
INTERIOR SURFACES
After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
oven to cool completely and then wipe it with a cloth
or sponge. Clean the glass in the door with a suitable
liquid detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they are
still hot.
Food residues can be removed using a washing-up
brush or a sponge.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lift the catches,
pushing them forwards until they are in the unlock
position (1). Close the door as much as you can. Take a
rm hold of the door with both hands – do not hold it
by the handle. Simply remove the door by continuing
to close it while pulling it upwards at the same time
until it is released from its seating (2). Put the door to
one side, resting it on a soft surface.
1
b
a
2
a
b
~15°
Ret the door by moving it towards the oven, aligning
the hooks of the hinges with their seating and secur-
ing the upper part onto its seating. Lower the door
and then open it fully. Lower the catches into their
original position (3): Make sure that you lower them
down completely.Apply gentle pressure to check that
the catches are in the correct position.
3
b
a
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above: The door could become damaged if
it does not work properly.
REPLACING THE LAMP
Disconnect the oven from the power supply, unscrew
the cover from the light, replace the bulb and screw
the cover back on the light. Reconnect the oven to
the power supply.
Please note: Only use 20-40 W/230 V type G9, T300 °C halogen
bulbs. The bulb used in the product is specically designed
for domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009). Light bulbs
are available from our After-sales Service. If using halogen bulbs,
do not handle them with your bare hands as your ngerprints
could cause damage. Do not use the oven until the light cover
has been retted.
BEFORE USE
Make sure that the oven has cooled down before carrying out any maintenance or cleaning.
Do not use steam cleaners.
Do not use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these could damage
the surfaces of the appliance.
Wear protective gloves.
The oven must be disconnected from the mains before carrying out any kind of maintenance work.