Manual

TheSTARTcontrolwillstartanyfunction.
Ifcookingisinterrupted,touchingtheSTARTcontrolpadwill
resumethepresetcycle.
Foraddedconvenience,the"Start"touchpadisalsoavailableon
somedisplayscreens,andprovidesthesamefunctionasthe
STARTcontrolpad.
Thenumericalpads1-5sharefunctionwiththeEasyMinute
controls.Whenoneofthesecontrolsistouched(whileno
functionisoperating),theovenwillbegincookingathighpower
for1-5minutes,dependingonwhichpadistouched.After
cookingbegins,theEasyMinutecontrolsreturntotheirnormal
numericalpadfunction.
TheADD30SEC.controlstartstheovenat100%powerfor
30seconds,andadds30secondsofcooktimewitheach
additionaltouchofthecontrol.Oncecookingbegins,cookpower
orcooktimemaybechangedmanuallybytouchingthe
appropriatedisplayareaandenteringthenewsetting.
TheCANCELpadstopsmostfunctionsexceptfortheTimer,
ChildLockandLearningMode.
Theovenwillalsoturnoffwhenthedoorisopened.Closethe
doorandtouchSTARTorthe"Continue"displayareatoresume
thecycle.Asensorcookingcyclemaynotberesumedif
interruptedbyopeningthedoor.
Thisisa12-hourclock,showinga.m.andp.m.Whenpoweris
firstsuppliedtotheoven,orafterapowerfailure,the"Home"
screenwillappear.
ToSetClock:TouchCLOCK,andfollowdirections.
ToHideClock:TouchCLOCK,thentouchCANCEL."Home"will
appearinplaceofthetimeofdayondisplayscreen.
ToDisplay Clock: Touch CLOCK, then touch START.
Tones are audible signals, indicating the following:
One tone
• Valid entry(short beep)
• End of Timer countdown (long tone)
Two tones
• Reminder (short beeps), repeat each minute for 15 minutes
after the end-of-cycle tones
• Between stages (short beeps)
Three Tones
• Invalid entry (short beeps)
Four tones
• End of cycle (long tones)
To Disable Tones: Turn volume off using the "Hints & Settings"
menu.
The Timer can be set in minutes and seconds, up to 90 minutes,
and counts down the set time.
NOTE: The Timer does not start or stop the oven.
8:16 A
(000,1( )
Menu
A. Timer countdown
When the Timer is in use, the oven can still operate. During an
oven operation, "Timer" will appear in the upper, right-hand
corner of the display. The countdown may also be seen by
touching TIMER SET-OFR Touch "Return" to go back to the
previous screen or wait for the timer to end. If the timer ends
while oven is still operating, the tone will sound and the display
will return to the set operating mode.
To Set: Touch TIMER SET-OFF, enter desired time and touch
"Start." The time can be reset during the countdown by touching
TIMER SET-OFF, entering a new time, then touching START.
To Cancel: Touch TIMER SET-OFF twice.
The vent fan has 4 speeds ranging from Off to High.
To protect the oven, the vent fan will automatically turn on at high
speed if the temperature from the range or cooktop below gets
too hot. It may stay on for up to 1 hour to cool the oven. When
this occurs, the Vent Fan pad will not function.
• A few seconds after the last time the Vent Fan pad is
touched, the screen returns to the previous display.
The first time the vent fan is turned on after power is
connected to the oven, the fan will start at high speed. The
next time the vent fan is turned on, it will start at the last
speed used.
To Turn Vent Fan On/Off: Touch VENT FAN to turn fan on, then
touch "+" or "-" on the display screen to select fan speed. Touch
the Vent Fan pad twice to turn the fan off (or once if Fan screen is
active).
The cooktop/countertop light has numerous brightness settings
ranging from Off to High. The light can be turned on manually, or
the Night Light can be programmed to come on automatically
when the sensor detects low light level. See "Night Light"
section.
To Manually Turn Light On/Off: Touch the LIGHT control pad to
turn light on. Touch "+" or "-" on the display screen to set desired
brightness level. Touch LIGHT pad twice to turn light off (or once
if Light screen is active).