Installation guide

E ®Ct_SCC_ _8@C
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances. A 120 Volt, 60 Hz,
AC only, 15- or 20-amp fused electrical supply (or circuit breaker)
is required. (A time-delay fuse or circuit breaker is recommended.)
It is recommended that a separate circuit serving only this
appliance be provided.
GROUNDING INSTRUCTIONS
[] For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
INSTALLATIONINSTRUCTIONS
l 8emov® 1VSoJnt ng
NOTE: To avoid possible damage to the work surface, place a
protective cover on the work surface.
1. Remove any remaining contents from the oven cavity.
2. Remove the mounting plate by peeling off the strips of tape
that attach it to the back of the oven, and set the mounting
plate aside.
Conv®d Ov4s n Exhs nc> ng
The oven is set for ventless (recirculating) installation. For wall or
roof venting, changes must be made to the venting system.
NOTE: Skip this section if you are using ventless (recirculating)
installation. Keep the damper assembly in case the venting
method is changed, or the oven is reinstalled in another location
where wall or roof venting may be used.
To prepare the oven for wall or roof venting, the vent deflector (L-
shaped metal bar) must be installed, and the appropriate damper
vent opening must be uncovered.
To Install Vent Deflector:
1. Gently pull the rings and lift vent screen from the top of the
oven.
A
B C
A. Mounting plate
B. Back of oven
C. Tape (multiple locations)
3. Tape the oven door closed so that door does not swing open
while the oven is being handled.
NOTE: Do not grip or use the door or door handle while the oven
is being handled.
B C
A. Top of oven
B. Vent screen
C. Rings