Installation guide

U ii nli,
1. 18. 19. 20. 21.22. 23. 24. 26.
•
8.11. 17.
4. 6. 7. 10. 12. 14. 15.
Numbers
correspond
to steps.
•
25.
25.
o
°I°
o
[] Measure the bottom of the upper
cabinet frame. Trim the edges "A', "B" and
"C" on the upper cabinet template so that
the template will fit on the bottom of the
upper cabinet, if upper cabinet has a
recessed frame, trim template so that it fits
inside the recessed area. Align the
centerline of the upper cabinet template
with the centerline of the wall template;
then securely tape or tack the upper
cabinet template in place,
Electrical Shock Hazard
Take special care when drilling holes into
the wall.
Electrical wires may be concealed behind
the wall covering, and contact with them
could result in death or serious injury.
,, Find the points on the wall template
labeled "D", "E', "F', and "G". Drill a 3/16""
diameter hole at the points that are over a
wall stud and a 3/4" diameter hole at the
points that are over drywall.
[]i
___,_____1e_. _ _L _ _'"'_ _ _ _ F
[] Locate the wall stud closest to the
center of the areas marked "H" and "1" on
the wall template. Drill 3/16"' holes into the
wall stud in each of the areas, if a wall stud
isnot located within these areas, drill 3/4"
diameter holes nearest to the center of the
areas as possible,
If there is not a wall stud within the areas
marked "H" and "l" and not behind points
marked "D","E ", "F" and "G', DO NOT
install microwave oven hood. (Consult
building inspector.)
Electrical Shock Hazard
Install power supply cord bushing around
hole drilled in metal cabinet.
Failure to do so could result in death or
serious injury.
[] Cut out or drill a 2" diameter hole at
the area marked "M °, "power supply cord
hole" on the upper cabinet template. If
upper cabinet is metal, install power supply
cord bushing around the edge of hole to
prevent damage to the cord from the
rough metal edge,
[] Determine which venting method
(roof-venting, wall-venting, or ventless) you
need to use. This microwave oven hood is
manufactured for ventless (recircuiating)
installation. Make adjustments to
microwave oven hood if wall- or roof-
venting installation is needed. See "Venting
preparation," Panel C.
0 [] Forventless installations, go to
Step 14,
To vent through the roof, cut out the
rectangular area marked "L" on the upper
cabinet template,
To vent through the wall, cut out the
rectangular area marked "O" on the wall
template.
n [] Drill a 3/8" hole at points "J", "K',
.I
and "N" on the upper cabinet template.
Remove the upper-cabinet and wall
templates.
filler block
upper cabinet bottom
masking tape
If boffom of upper cabinet is recessed,
2" x 2" filler blocks (not included) the same
recess thickness as the upper cabinet will
be needed. Mark the center of each filler
block and drill a 3/8" diameter hole at the
marks. Align filler blocks over the two holes
"J" and "K" in the cabinet bottom and
attach to cabinet bottom with masking
tape.
Panel D