Installation guide

1 2 J Roof venting: Do Not install 161 Slide
ductwork at this time. Go to Step 14. washer onto lock
Wall venting: Install ductwork through the
vent opening in the wall. Complete the
venting system through the wall according
to the method needed. See "Venting
requirements" and "Venting preparation,"
Panels B and C. Use caulking to seal exterior
wall opening around exhaust cap.
pin and set inside
upper cabinet,
3. If wall-
venting installation is
used, attach damper
to rear of mounting
plate. Align 3-1/4"x 10"
duct with damper and
see that damper
moves freely.
damper
Injury Hazard
Two people are required to lift this
microwave oven hood.
Lift microwave oven hood and hang on
support tabs on bottom of mounting plate
brackets. Hold microwave oven hood in
place and secure to upper cabinet with
the lock pin and washer.
Failure to follow these instructions could
result in injury.
/mounting plate
L
'e
_'_.-_. mounting plate
.
toggle bolts (drywall) through the holes on
the mounting plate where the mounting
plate will be attached to wall stud or
drywall at holes "D', "E", "F", "G", "H"
and "1".
of spr
toggle
boll_
\
to end
wall
plate
//
//
//
//
//
//
//
Attach a spring toggle head to the end of
each toggle bolt. Leave at least one wall
thickness of space between the mounting
plate and the end of the spring toggle
head so that the spring toggle head can
properly open on the other side of the wail.
support tabs
7 • Carefully lift microwave oven
hood and hang it on support tabs at the
bottom of the mounting plate. Thread
power supply cord through the power
supply cord hole in the bottom of the upper
cabinet,
8 • Rotate microwave oven hood
upward so that top of hood is against
bottom of upper cabinet or cabinet frame.
I
o
19 "-
• Drop the lock pin and washer
assembly into hole "N" and push pin down
as far as it wirl go,
1 • Remove locking pin and washer.
If wall-venting or ventless installation is used,
go to Step 24.
t II u iI
22 • Roof-venting installafon: Align
the damper/duct connector with the vent
on top of the microwave oven hood.
Damper should be on top of tab. Use two
tapping screws (bright-colored) to attach
damper/duct connector to the microwave
oven hood.
Note: Damper/duct connector must be
attached to microwave oven hood oiler
microwave oven hood is installed.
power
t_J _,_J} _ supply
I_/-_/ I\ cord
_;;;;=;_ _'_-_ 1 clamp
Roof-venting installation: Install
ductwork through the vent opening in the
upper cabinet. Complete the venting
system through the roof according to the
method needed. See "Venting
requirements" and "Venting preparation,"
Panels B and C. Use caulking to seal
exterior roof opening around exhaust cap.
4 • Install power supply cord clamp,
using screw as shown in Step 23, to inside of
the cabinet. Use power supply cord clamp
to bundle the power supply cord,
Grasp filter screen with one hand
holding the ring and the other hand
holding the opposite end. Insert the end of
the filter screen without ring into the
opening and slide towards the center of
the microwave oven hood, Insert ring end
of filter screen into the opening and slide
entire screen towards the side of the
microwave oven hood until screen is
securely in position. Repeat for other filter
screen.
6 • Plug in the power supply cord.
Position mounting
plate on the wall
making sure that
top of mounting
plate is against
bottom of Make sure top of mounting
plate is against bottom of
cabinet or cabinet or cabinet frame.
bottom of
cabinet frame, Start the lag screws through
the waDstud holes and/or insert toggle bolts
and spring toggle heads through drywall
holes, Tighten screws and/or bolts to secure
mounting plate to wall. Check that center
of bracket is secured to wall
Panel E
0 • Place washers over two, 1/4" x 3"
bolts. Then insert a bolt down through each
hole in the upper cabinet bottom, Tighten
the bolts until the gap between the upper
cabinet and microwave oven hood is
closed.
Read your Use and Care Guide,
then check the operation of your
microwave oven hood.
Gu_l_ion Instructions 1
Congratulations! I
ond_lo_ to m_row_e oven /
hood for easy reference. The instructions/
_ling your microwave /