Setup and user guide

ManualsBrandsWhirlpool ManualsOtherGKIE 2B19

DAILY REFERENCE

GUIDE

You can download the Safety Instructions and the Use and Care Guide, by visiting our website

docs.whirlpool.eu and following the Instructions on the back of this booklet.

Before using the appliance carefully read Health and Safety guide.

PRODUCT DESCRIPTION

APPLIANCE

1. Upper rack

2. Foldable flaps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Cutlery basket

7. Lower spray arm

8. Filter Assembly

9. Salt reservoir

10. Detergent and Rinse Aid dispensers

11. Rating plate

12. Control panel

0000 000 00000

Service:

CONTROL PANEL

1. On-Off/Reset button with indicator light

2. Program selection button

3. Program indicator lights

1 2

Summary of content (8 pages)

PAGE 1
EN DAILY REFERENCE GUIDE You can download the Safety Instructions and the Use and Care Guide, by visiting our website docs.whirlpool.eu and following the Instructions on the back of this booklet. Before using the appliance carefully read Health and Safety guide. PRODUCT DESCRIPTION APPLIANCE 1 7 2 8 3 4 5 9 1. Upper rack 2. Foldable flaps 3. Upper rack height adjuster 4. Upper spray arm 5. Lower rack 6. Cutlery basket 7. Lower spray arm 8. Filter Assembly 9. Salt reservoir 10.
PAGE 2
FIRST TIME USE SALT, RINSE AID AND DETERGENT ADVICE REGARDING THE FIRST TIME USE FILLING THE RINSE AID DISPENSER After installation, remove the stoppers from the racks and the retaining elastic elements from the upper rack. Rinse aid makes dish DRYING easier. The rinse aid dispenser A should be filled when the dark optical indicator on the dispenser door C becomes transparent..
PAGE 3
EN PROGRAMS TABLE Drying phase Program Detergent container Tub B Duration of wash program (h:min)*) Water consumption (litres/cycle) Energy consumption (kWh/cycle) 3:20 12.0 1.04 1. Eco 50° 2. Intensive 65° - 2:30 15.0 1.50 3. Normal 55° - 2:00 15.0 1.35 4. Pre-Wash 0:10 4.5 0.01 - - - - ECO program data is measured under laboratory conditions according to European Standard EN 50242.
PAGE 4
DAILY USE 1. CHECK WATER CONNECTION Check that the dishwasher is connected to the water supply and that the tap is open. 2. SWITCH ON THE DISHWASHER Open the door and press the ON/OFF button. 3. LOAD THE RACKS (see LOADING THE RACKS) 4. FILLING THE DETERGENT DISPENSER (see PROGRAMS TABLE). 5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE Select the most appropriate program in accordance with the type of crockery and its soiling level (see PROGRAMS DESCRIPTION) by pressing the P button. 6.
PAGE 5
EN LOADING THE RACKS UPPER RACK LOWER RACK Load delicate and light dishes: glasses, cups, saucers, low salad bowls. For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids should ideally be placed at the sides to avoid interferences with the spray arm.
PAGE 6
CARE AND MAINTENANCE CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS Regularly clean the filter assembly so that the filters do not clog and that the waste water flows away correctly. The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water: to obtain the best washing results, you need to keep them clean. The dishwasher must not be used without filters or if the filter is loose.
PAGE 7
EN TROUBLESHOOTING Your dishwasher may not work properly. Before contacting the Service Centre check if the problem can be solved by going through the following list. PROBLEMS POSSIBLE CAUSES The dishwasher The appliance has not been plugged in won’t start or does properly. not respond to comPower outage. mands. SOLUTIONS Insert the plug into the socket. The dishwasher starts automatically when the power returns. The dishwasher door is not closed. Vigorously push the door until you hear the “click”.
PAGE 8
400011299243 08/2018 as - Xerox Fabriano 8