Installation guide

ManualsBrandsWhirlpool ManualsRangeOfficial Whirlpool electric freestanding range

Jnstailati Jnstructi

Tip Over Hazard

A child or adult can tip the range and

be killed.

Connect anti-tip bracket to rear

range foot.

Reconnect the anti=tip bracket, if the

range is moved.

Failure to follow these instructions can

result in death or serious burns to

children and adults.

Quick Reference

Table of Contents:

Pages

%-I_

9758641

Before you start

Product dimensions

Cabinet dimensions requirements

Electrical requirements

Installation steps

Check operation

If range does not operate

If you need assistance _service

Moving the range

IMPORTANT:

Read and save these instructions.

www.whirlpool.com

iMPORTANT:

installer: Leave Installation

Instructions with the homeowner.

Homeowner: Keep Installation

Instructions for future reference.

Read and save these instructions for

local electrical inspector's use.

Write down the model and serial

numbers before installing range.

Both numbers are listed on the

model/serial rating plate located

on the oven frame behind the

storage drawer panel.

Model #

Serial # Part No. 9758641

Summary of content (12 pages)

PAGE 1
m Jnstailati Jnstructi 9758641 Quick Reference Table of Contents: Pages Before you start Product dimensions Tip Over A child or adult be killed. Connect anti-tip range foot. can tip the range bracket Reconnect the anti=tip range is moved. Cabinet dimensions requirements Hazard Electrical requirements and %-I_ to rear bracket, Check operation If range does not operate if the Failure to follow these instructions result in death or serious burns to children and adults.
PAGE 2
Mobile Before you start... Your safety and the safety others are very important. of We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING.
PAGE 3
Product dimensions 46-13/16" (119.0 cm) overall height 24-1/2" (62.2 cm) Cabinet dimensions/requirements Cabinet opening dimensions shown are for: 25" (63.5 cm) countertop depth, 24" (61 cm) base cabinet depth, 36" (91.4 cm) countertop height For minimum clearance to the / top of the cooktop, see NOTE.* 13" (33 cm) max. / upper cabinet dept 30" (76.2 cm) min. cabinet opening width 18" (45.7 cm) upper side cabinet to countertop 30-3/8" (77.2em) opening width I I I 4" (10.2 cm) min.
PAGE 4
Electrical requirements if codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path and wire gauge are in accordance with local codes. This range must grounded metal, system. [] The range can be connected directly to the fused disconnect (or circuit breaker box) through flexible armored be connected to a permanent wiring Allow two to three feet Check with a qualified electrician if you are not sure range is properly grounded.
PAGE 5
Now start... Electrical Excessive Weight Use two or more install range. = Remove Hazard people to move Failure to do so can result other injury. located and in back m Remove shipping materials, tape and protective film from range. Keep cardboard bottom and shipping base under range. Remove oven racks and parts package from inside oven. m from the corner on top of another. Repeat with other two corners.
PAGE 6
Power supply cord method: NOTE: The bag containing three aluminum terminal lugs is not used when connecting the range using a power supply cord. 5. Use either ring-type terminals spade terminals with upturned to connect the power supply. or ends 6. Complete electrical connection according to your type electrical supply ("Four-wire electrical connection" or "Three-wire electrical terminal connection") Four-wire electrical 10.
PAGE 7
Direct wire method: Copper or Aluminum NOTE:The bag containing three aluminum terminal lugs must be used when making a direct wire connection. 7. 8. IMPORTANT: wire the aluminum terminal lugs must be assembled terminal posts with the facing out as shown. to the set screws Attach three aluminum to terminal posts. terminal lugs Use a 3/8" nut driver and tighten the nuts securely. Nuts must be tightened to 20 in/Ibs of torque for proper electrical connection. 9.
PAGE 8
Operating position m Move range close to cabinet [] Make sure the anti-tip bracket bracket securely is installed: opening. O[] Remove cardboard . Look for the anti-tip attached to floor. or hardboard from under range. Carefully move range into final position. [] Pull drawer open to first . Slide range back so rear is under anti-tip bracket. range 14[] Place on rack, first back. rack in oven. side to side; then Place level front to foot stop position.
PAGE 9
Check operation 2. = Check the operation of the cooktop elements: Push in and turn each surface unit control knob to "HI" position. Check the operation of the cooktop elements and indicator lights. OO FRONT 0O Press the "START/ENTER" "START" pad. ,The "ON" indicator • The "TEMP" or will light. indicator temperature ("350") counting down. • The bottom red. element and should • The upper element should hot, but not glow red. 3.
PAGE 10
If range does not if you need assistance: If you need service: operate: if you have questions about operating, cleaning or maintaining your range: Maintain the quality built into your range by calling an authorized service company. [] Check that the circuit breaker is not tripped or the house fuse blown. [] Check that the power supply cord is plugged into the outlet. [] See Use and Care Guide for troubleshooting list. [] Refer to Use and Care Guide. [] Call the Customer interaction Center.
PAGE 11
Notes 11