Installation guide

Cutoutdimensions/requirements
25"(63.5 cm)countertopdepthand
24"(61 cm)basecabinetdepth,
36"(91.4 cm)countertopheight _
jFor minimum
I 2.... --clearancntothe
30" (76.2 cm) rain. topof thecooktop,
t8°(46.7cm)
upper cabinet I
to counterlop _ 30" 76.2 cm) _
] opening width _'_
I
I
4" 10.2 cm
m n. Cearance from f
bothsidesofrange
tosidewallorother
combustible
material.
i
I
i
recepticalor
unctionbox-
• 8 20.3cmto
22" 55.9cm) from
ethercabnet,
7" 17.8cm)max.
fromf nor.
_ required between
cutout and cabinet
door or hinge.
I 1 -_
* Note:24"(61cm)rain.whenbottomofwoodormetalcabinetis
protectedby notlessthan1/4"(0.64 cm) flameretardantmillboard
coveredwithnotlessthanNo.28MSGsheetsteel,0.015"0.4mm
stanessstee,0.024"0.6mm aumnoraor0.020"(0.5ram)copper.
30" 76.2cm) rain.clearancebetweenthetopofthecooking platform
andthebottomo anunprotectedwoodormetacabnet.
Productdimensions
43" (109.2 cm)
overall height
36" (91.4 cm)
cooktop
height with
feet loosened
1=1/2 turns
30"
76.2 cm)
27-3/4" _ J w dth
(70.5cm) ]
depth "_
When installed in a 24" 61 cm) base cabinet with 25" (63.5 cm)
countertop-- font o oven door protrudes1-7/8" 4.8 cm beyond
24" (61 cm) base cabinet.
Anti-tipbracket:
....... The floor anti-tip bracket
i _ MUST be installed.To install
"_ , _ the anti-tip bracket shipped
_ _.';_,_ with the range, see Page 7 and
the anti-tip bracket template.
Electrical
requirements
Electrical Shock Hazard
Electrically ground range.
Failure to follow these
instructions can result in death,
fire, or electrical shock.
If codes permit and a separate
ground wire is used, it is
recommended that a qualified
electrician determine that the ground
path is adequate.
Do Not ground to a gas pipe.
Check with a qualified electrician if
you are not sure range is grounded.
Do Not have a fuse in the neutral or
ground circuit.
A= When a four-wire or three-wire,
single- phase, 120/240wolt, 60-Hz, AC-
only, electrical supply is available, a 50-
ampere maximum circuit protection is
required, (or, if specified on the
model/serial rating plate, when a four-
wire or three-wire, single-phase
120/208-volt, 60 Hz, AC-only electrical
supply is available, a 40-ampere
maximum circuit protection is required),
fused on both sides of the line. A time-
delay fuse or circuit breaker is
recommended. The model/serial rating
plate is located on the oven frame
behind the drawer.
B= Wire sizes and connections must
conform to the requirements of the
National Electrical Code, ANSI/NFPA
70 -- latest edition* or CSA Standard
C22.1, Canadian Electrical Code,
Part 1 -- latest edition** and all local
codes and ordinances for the kilowatt
rating of the range.
Copies of the standards listed may be obtained
from:
* National Fire Protection Association
Batterymarch Park
Qoincy, Massachusetts 02269
** CSA International
8501 East Pleasant Valley Road
Cleveland, Ohio 44131.5575