Installation guide

Four-wireelectrical
connection:
gr0und-link
groundlinkj _ screw
8. Remove the ground-link screw from
the range frame. Save the ground-link
screw.Bend up the ground link so that
it does not contact the range.
ground*link
screw
barewire j
fr0mp0wer
supplycable
9. Connect the green ground wire
from power supply cord to the
range using the ground-link screw.
The ground wire must be
attached first and must not
contact any other terminal.
silver-coloredterminal
block scr_
_-/i iZ (whitewire)
barewire_ \_L_ _/'_
frompow: f j.
supply cable _ _L._
U.L listed conduit
j,_ _ connectorand power
supplycable
10. Connect the neutral wire (white
wire) to the center, silver-colored
terminal screw on the terminal
block using the brass nuts that are
attached to the terminal block
cover.
11. Connect the other two wires to the
outer terminals on the terminal
block.
12. Do Not loosen the factory installed
nuts already on the terminal.
Tighten nuts with 3/8" nut driver for
proper electrical connection.
13. Tighten the locking ring and
clamping screws of the conduit
connector.
14. Replace the terminal block cover.
Three-wireelectrical
connection:
silvePcolored terminal
block screw
\\
_ '_'_line 2
qround _ _neutral wire
,.k : wb,ow,e)
line 1 U.L. listed conduit
connectorand power
supply cable
Use this method ONLY if local
codes PERMIT connecting cabinet-
ground conductor to neutral wire
of power supply cable,
7. Use the brass terminal nuts
attached to the knckout opening to
connect the neutral wire (white
wire) to the silver-colored terminal
screw on the terminal block.
.
9.
Connect the other two wires to
outer terminal screws on the
terminal block.
Do Not loosen factory-installed
nuts already on the terminal.
Tighten nuts with 3/8" nut driver
for proper electrical connection.
10. Tighten the locking ring and
clamping screws of the conduit
connector.
11. Reinstall the terminal block cover.
Nowstart...
With range in kitchen.
= Put on safety glasses and
gloves. Remove shipping materials,
tape and protective film from range.
Keep cardboard bottom and shipping
base under range. Remove oven racks
and parts package from inside oven.
:,cardboard
corners
spacers
• Take 4 cardboard corners from
the carton. Stack one cardboard corner
on top of another. Repeat with the other
two corners. Place corners lengthwise
on the floor in back of range so corners
wilt support outer side edges of range
as shown.
Excessive Weight Hazard
Use two or more people to move
and install range,
Failure to do so can result in back
or other injury.
• Firmly grasp the range and gently
lay it on its back on the cardboard
corners.
• Pull cardboard bottom and
shipping base firmly to remove.
S
• Use an adjustable wrench to
loosen the leveling legs 1-1/2 turns.
6