94001-gb.
94001-gb.fm5 Page 67 Wednesday, September 26, 2001 6:12 PM BEFORE USING THE DISHWASHER • • After unpacking, make sure the appliance is undamaged and that the door closes correctly. Do not use the appliance if it is damaged. If in doubt, consult your local retailer. Keep potentially hazardous packaging (plastic bags etc.) out of the reach of children. • • This appliance is designed for use in the home in compliance with its intended purpose.
94001-gb.fm5 Page 68 Wednesday, September 26, 2001 6:12 PM HOW TO FILL THE SALT CONTAINER Check the water hardness level in your area. Consult your local Water Board or check your last water bill. • Set the water hardness by turning the selector (if fitted) inside the door (top left) with a screwdriver. Use the table below to set the dial to the required setting.
94001-gb.fm5 Page 69 Wednesday, September 26, 2001 6:12 PM HOW TO FILL THE RINSE AID DISPENSER The rinse aid facilitates drying and prevents the formation of unsightly spots and streaks on crockery. Before using the dishwasher for the first time, fill the rinse aid dispenser. Thereafter, regularly check the rinse aid level. Only use rinse aids recommended for use in domestic dishwashers. A 1. Unscrew the cap and press button A (see drawing).
94001-gb.fm5 Page 70 Wednesday, September 26, 2001 6:12 PM HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use “new generation” enzyme-based detergents, select the Bio programmes which are also suitable for all normal detergents. If you use detergents in pellet form, follow the manufacturer's directions for use. Always use the recommended dosage stated on the detergent pack.
94001-gb.fm5 Page 71 Wednesday, September 26, 2001 6:12 PM HOW TO USE THE DISHWASHER Close the dishwasher door and turn on the water tap. 1. Press the ON/OFF button to switch on the dishwasher. One of the programme indicator lamps will illuminate. 2. Select the required programme by pressing the programme button. The corresponding indicator lamp will illuminate. If required, select any additional functions. 3. Press the Start button to start the selected wash programme.
94001-gb.fm5 Page 72 Wednesday, September 26, 2001 6:12 PM CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. • The inlet hose must be securely clamped to the water tap to prevent leaks.
94001-gb.fm5 Page 73 Wednesday, September 26, 2001 6:12 PM CONNECTIONS 1) ELECTRICAL CONNECTIONS “Warning - this appliance must be earthed” This appliance is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below.
4001-gb.fm5 Page 74 Wednesday, September 26, 2001 6:12 PM MAINTENANCE AND CLEANING Before cleaning or carrying out maintenance, press the ON/OFF button. 1. Clean the appliance exterior with a neutral detergent. Do not use abrasive detergents. 2. Regularly wipe the door seal and inside of the door with a damp cloth to remove any food residues.
94001-gb.fm5 Page 75 Wednesday, September 26, 2001 6:12 PM TROUBLESHOOTING GUIDE If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem. Restart the wash programme to see if the fault repeats. • Press the Start button for about 5 seconds until the Start indicator lamp switches off. • Briefly press the Start button. If the malfunction persists, switch off the appliance and turn off the water tap. Call our After-Sales Service.
