Instruction for Use

1
GB
Before using the dishwasher, read the
installation and maintenance instructions carefully!
5019 496 01106
GSI 110 Eco
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on the EN comparison test and
other tests, contact the following address: “[e-mail]”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on. Standard NF EN 13697 - November 2001.
1. OVERVIEW
Programme selection button
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
START
button reset function
Press this button for at least 2 seconds; the selected programme
and options are cancelled. Main failure displays (repeated flashing
of the START indicator lamp) can be cancelled by RESETTING.
Detailed instructions are given in chapter “What to do if...”.
Salt level indicator and rinse aid level indicator
These indicator lamps light up when salt or rinse aid need to be added.
Add just before starting a wash cycle.
F
ault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (hh).
If “F..” – appears on the display, see chapter 5 “What to do if...”.
D
elayed start button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time
Detergent setting upon initial use and when using a different type of detergent
1. Select the third programme in the relative table.
2. Press the START button for about 7 seconds. to change the display.
3. Using the START button, select the desired detergent:
Display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action
detergents (in this way, the rinse aid and/or salt indicator is deactivated).
Display shows OFF = Powder detergent (factory setting).
rinse aid level and salt level indicator activated.
4. Switch the appliance off and then switch it on again. The selected detergent
type will be indicated on the display for approx. 3 seconds .
Half Load/Multizone
Load the upper or lower rack only.
Press once = wash upper rack (the indicator light/symbol lights up)
Press twice = wash the lower rack (the indicator light/symbol lights up)
Press 3 times = Off (Half load/Multizone deactivated).
When washing without the top rack, press the “Half load” (i.e.
“wash bottom rack”) button. twice (the corresponding indicator/
symbol lights up).
O
n /Off button
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Selectable
extra
functions
Description of programme large small Litres kWh Minutes
1
40-70°C
Normally or heavily soiled crockery, including
pots and pans.
X X 7-17 0.99-1.75 65-220 ±
1)
2
Pre-Rinse cold
Crockery to be washed later.
— — 4.0 0.03 14 ±
1)
3
Glasses 40°C
Lightly soiled crockery, e.g. glasses and cups,
with a lower pressure jet.
X — 10.0 0.85 100 ±
1)
4
Quickwash 40°C
Lightly soiled crockery, with no dried-on food.
X — 10.0 0.65 30 ±
1)
5
Bio Normal
2)
50 °C
Normally soiled crockery. Energy-saving
programme with prolonged drying.
X X 13.0 0.93 200 ±
1)
6
Hygienic +
3)
Normally or heavily soiled crockery, with
additional antibacterial wash. Programme
interruption (e.g. due to door opening) can
compromise elimination of germs.
X X 13.0 1.50 115 ±
1)
7
Nightrinse 55°C
Normally soiled crockery, gentle and quiet
thanks to the lower spray pressure (39dbA).
X X 13.0 1.20 290 ±
1)