Instruction for Use

1
GB
Before using the dishwasher, read the
installation and maintenance instructions carefully!
5019 496 01101
GSX 5961
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads,
extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on the
EN comparison test and other tests, contact the following address: “[e-mail]”.
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with Standard NF
EN 13697 - November 2001.
ON button
OFF button
Programme selection button
Press button P (repeatedly) until the required
programme number appears on the display.
Fault indication and wash time display
In normal operation it indicates the remaining time
(h:mm), whereas with “Delayed start” selected it
indicates the time remaining until programme start (hh).
In the presence of a fault indication “F..” –, consult the
section “5. What to do if …”.
An acoustic signal sounds as long as the error persists.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Set the detergent
Press button P (repeatedly) to set the type of detergent used.
This deactivates the rinse aid and/or salt indicator.
Half Load/Multizone button
Load the top
or
bottom rack
only.
Press once = wash
top rack
(the indicator/symbol lights up)
Press twice = wash
bottom rack
(the indicator/symbol
lights up)
Press 3 times =
Off
(Half load/Multizone deactivated).
When washing without the top rack, press the “Half
load” (i.e. “wash bottom rack”) button. “twice (the
corresponding indicator/symbol lights up).
Powder, gel, tablets (standard): indicator off
Detergent with rinse aid: left indicator
Detergent with salt + rinse aid: right indicator
Power Clean
High pressure with an additional jet for better washing
results and greater bottom rack load flexibility.
“Delayed start” button
Press the button (repeatedly) to delay the start of the
programme. Adjustable from 1 to 24 hours. With each
press of the button, the delayed start indicator increases
by one hour and after 24 restarts from 00. Then press
the START button. The dishwasher will start after the set
time.
START button
The indicator lights up during operation, flashes when a
fault occurs, and goes off at the end of the programme.
RESET button - for programme change or indication of
faults
Press this button to cancel a started programme and
selected extra functions. Press this button to cancel the
main fault indicators (F..); also refer to the section “5.
What to do if...”. The programme can then be selected
and started.
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Selectable
extra
functions
Loading instructions large small Litres kWh Minutes
1
40-70°C
Normally or heavily soiled crockery, including
pots and pans.
X X 7-17 0.99-1.75 65-220 ±
1)
2
Pre-rinse cold
Crockery to be washed later.
— — 4.0 0.03 14 ±
1)
3
Glasses 40°C
Lightly soiled crockery, e.g. glasses and cups, with
a lower pressure jet.
X — 10.0 0.85 100 ±
1)
4
Quickwash 40°C
Lightly soiled crockery, without dry residuals.
X — 10.0 0.65 30 ±
1)
5
Bio
2)
50°C
Normally soiled crockery. Energy-saving
programme with prolonged drying.
X X 13.0 0.93 200 ±
1)
6
Hygienic +
3)
Normally or heavily soiled crockery, with
additional antibacterial action. An interruption of
the programme (e.g. due to door opening) can
compromise elimination of germs.
X X 13.0 1.50 115 ±
1)
7
Overnight 55°C
Normally soiled crockery, gentle and quiet (39
dbA) thanks to the lower pressure jet.
X X 13.0 1.20 290 ±
1)